Search:

still no luck with wreckers, ebay, gumtree starting to think give up and put the 5 litre in :(

i sure hope so

bumping this

the issue i have is i dont have a harness to go to fuelpump relay and eccs relay or any of the stuff that follows on from the 8 pin plug next to battery tray. if any one could assist as to where i...

death shakes came back in my blue rig the other day..... not a happy camper. replaced rear tie-rod ends fixed it again!

plenty of time for fourbie's on weekends when the handbrake allows it. come to think of it, i do spend alot more time on projects then actually driving them just of lately, a hobbies a hobbie i guess...

i have rear sway bar, dickie seat and power steering pump. the dickie seat is old trim pattern from my 1988 wags the rear sway bar is factory disconect type an needs new joints, im sure its the same...

Just thought i would throw this out there, I have a complete loom for a td42 1990 model, the belhousing needed for a diesel the starter motor and all the fuel lines and filter mounts for in the...

deja vu. lol cheers guys

thank you very much just what i need cheers mate

good thinking there.

hi darren i have a complete wiring loom with all the relays fuse panels fuel lines for under bonnet and the bell housing to suit if your interested pm me. i am also after a loom for a tb42e and fuel...

running 33's with 4.1 ratios. trial and error the first time only moved it a small amount anti clockwise and went out further so i went the other way a touch and got it spot on. had the car strapped...

sound like you got a good buy there jamied. ever since i purchased my 1988 tb42 all i seem to be doing to it is put fuel in, petronix is a good start but also look into a re-jet mine is down to...

just carry a pump water bottle with ya and give the window squirt now and then haha.

good bit of info this helped me out a fair bit no longer need gps to tell me the right speed.

mafless tune would be great, need to get the engine to run before i go to much further, it used to be a carbie engine still trying to get it all together in engine bay. Any info on these would be...

thanks for the tip Mudrunner will look into pic size. I also considered the vibration factor threedogs, the ideal bush would be a genuine trailing arm item as it is rubber and much softer than...

gotta love the tb42's, all good advise here surely on your way by now.

common issue with tb42 carbie's is the little s shaped vac hose that goes from the top engine side of the carb to the rear of the carb for the choke disengage, this can split quite easily causing a...

Also check for rust holes on the inside of your rear quarters. i have the same issue with my daily once the winows are wound up and the vent set open not recycle the fumes go away due to cab...

radius bushes could be stuffed, shock rubbers or the shocks could be stuffed, tie rods when worn tend to make a horrible noise when the shake starts, the actual bolt that holds the panard to the...

mine had the death shakes at 60kph found the panard rod was loose, had to replace top bolt, fixed it for a while then found radius arm bushes were shot so i replaced them, not long after it started...

sounds like a problem 2 of my gq's have. the lower shock mounts have seats the rubbers sit on, if they have become dislodged the shock pin rubs on the shock mount and makes for a very annoying drive....

thanks for the welcome tipical newbie i am, i didn't even realise i had done this yet ha ha oh well. Anyway i am from port augusta in south australia, love my back yard build-ups just starting to get...