OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: mudski

Page 1 of 20 1 2 3 4

Search: Search took 0.11 seconds; generated 11 minute(s) ago.

  1. Replies
    8
    Views
    334

    Was the air flow meter you changed out genuine?...

    Was the air flow meter you changed out genuine? Did you disconnect the -ive on the battery for half hour to reset the ECU? Check all the intercooler hoses, make sure there is no boost leaks. Go over...
  2. Replies
    1,906
    Views
    231,726

    Well it was my second time back to the far north...

    Well it was my second time back to the far north of the NT and OMFG! I could live up there in a heart beat. I need to gather the pics from my brother but here’s the list of the catch over the four...
  3. Replies
    11
    Views
    185

    I have seen them mounted between the grill and...

    I have seen them mounted between the grill and radiator. This was on the TI models where there’s zero room in the usual spot.


    Sent from my iPhone using Tapatalk
  4. Replies
    13,963
    Views
    1,110,161

    Sticky: Glow plug voltage is rated to 11V on those, so...

    Glow plug voltage is rated to 11V on those, so that sounds right to me. Unless the rail gets the full 12v and converts it at the plug. Not sure...
  5. Replies
    36
    Views
    1,412

    At a whole 97kw and 138Nm I think a 253 would go...

    At a whole 97kw and 138Nm I think a 253 would go better. But I'd love to have one sitting in my garage none the less.
  6. It will help if you tell us what was removed and...

    It will help if you tell us what was removed and reinstalled in the process of the manifold removal. Also try disconnecting the earth to the main battery for half hour to reset the ecu.
  7. Towing in OD is your issue. I believe. The lil...

    Towing in OD is your issue. I believe. The lil 3Ltrs don't like to be stressed in overdrive.
  8. Replies
    13,963
    Views
    1,110,161

    Sticky: yeah went and saw Ride Like a Girl yesterday with...

    yeah went and saw Ride Like a Girl yesterday with the wife and kid. Quite entertaining.
  9. Replies
    10
    Views
    339

    Clutch has gone or the clutch fork has broken at...

    Clutch has gone or the clutch fork has broken at the pivot I think. So you can put it into gear with the engine running and NOT putting the clutch in?


    Sent from my iPhone using Tapatalk
  10. Replies
    17
    Views
    361

    I would assume the signal line to the compressor...

    I would assume the signal line to the compressor from the switch is corrupt in some way. Is the switch single or two wires? If its two wires there should be current running through the switch when...
  11. No worries. I'll call you in the morning.

    No worries. I'll call you in the morning.
  12. I have to drop off parts to a customer in Yarra...

    I have to drop off parts to a customer in Yarra Glen in the morning. I can drop past and take a look if you like.
  13. Replies
    9,219
    Views
    805,622

    New alternator charging at its optimum over and...

    New alternator charging at its optimum over and older alternator, new starter motor not drawing as much current as an older starter would. I assume this would impact on battery condition to some...
  14. Replies
    36
    Views
    1,412

    October Photo Comp- Reflections

    Not much of a pic but this is what I had to put up with every evening whilst in the top end.

    79450

    Sent from my iPhone using Tapatalk
  15. Any luck mate?

    Any luck mate?
  16. Replies
    3
    Views
    144

    Looks like a full cooling system overhaul to me.

    Looks like a full cooling system overhaul to me.
  17. Recently bought a Fiskars X11 splitter. The X7...

    Recently bought a Fiskars X11 splitter. The X7 was too small and the one above the X11 was too big to split the smaller stuff. I got it from the UK cheaper with post anywhere cheaper I could find it...
  18. The engineering for my Patrol cost around $1600....

    The engineering for my Patrol cost around $1600. This was to engineer the entire vehicle. VASS approved engineer I used too. As the Police and the RTA cannot argue against a VASS engineer. Where they...
  19. Replies
    9
    Views
    210

    Great pics mate. I just came back from two weeks...

    Great pics mate. I just came back from two weeks up in the NT. Beautiful country for sure.
  20. Replies
    1
    Views
    70

    Never heard of the bases breaking but I know mine...

    Never heard of the bases breaking but I know mine have come lose. There is three screws in there from memory and I just nipped them up on my GU and now they dont shake around like they used too. So...
  21. Yeah should work in theory. It works on the...

    Yeah should work in theory. It works on the similar principle to an oil pressure switch, but is activated by heat. The switch is just an earth contact for the fan.
  22. Mark is the sensor two wire or single wire mate?...

    Mark is the sensor two wire or single wire mate? If single it should just be a simple switch, on (at the set temp) and off. So if you heat some water to the set temp, attach a DMM to the thread and...
  23. Replies
    9,219
    Views
    805,622

    Sorry John, I haven't been on much lately due to...

    Sorry John, I haven't been on much lately due to being in the NT but why have you got a louvered plate on the bonnet instead of the scoop?
  24. Replies
    3
    Views
    107

    Hi mate. Adding a lift pump is a good idea but it...

    Hi mate. Adding a lift pump is a good idea but it won’t give you anymore power. It’s all limited at the injector pump.


    Sent from my iPhone using Tapatalk
  25. Replies
    12,587
    Views
    1,071,681

    Sticky: What has made you Angry Today???????

    Yeah I need to think of other ideas for this wall. I’ve ask them to see how high we can actually go, if at all. Then we’ll take it from there.
    As for the NT we had no cooler than 36 for the entire...
Results 1 to 25 of 495
Page 1 of 20 1 2 3 4