Search:

Old thread revival... Colin retired some time ago. Any other recommendations in the north east?

A load of camping gear, but only two people. Not really a massive weight. I guess it's hard to compare with probe positions etc. My probe is probably a little off centre as I had to get a coupler in...

My CRD sits around 380-450 whilst driving 100km/hr at 10psi. The probe is post turbo in the dump pipe. Driving up the SE freeway out of Adelaide, it quickly climbed to 650-680 whilst doing 80km/hr -...

I have a very similar problem to this, but my indicator and rear light isn't working. Brake light is fine. Where abouts did you find the solder connection? My globe holders look fairly well sealed...

OK so apparently Auber didn't send me the wrong sensor fitting.. I just measured wrong. Unfortunately, seems the place in my exhaust is at least an M12 fitting which they don't sell.

Not sure...

I am thinking of probably putting the gauge in the middle compartment where the nav system is on the high end models. Then I can close the lid and hide it away at night. That being the case, I'll...

I've just bought an auber EGT gauge. Planning to install it this weekend, and am thinking of splicing into the cigarette lighter 12v source for power. Is it as simple as that, or do I need to add in...

Cheers. I'm in Adelaide

Gday

I've recently purchased a 2007 CRD. Loving the wealth of information on these forums.

The car came with a DPChip, 2.75" exhaust, and 2" lift, so already have a few mods covered. So far...

Gday - wondering where you purchased from to get $450? On ebay they're going for 590

Mine is leaking quite a bit of oil - time for a replacement!