OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: 82588

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    962

    Yeah mate, you have to remove the grill. The...

    Yeah mate, you have to remove the grill. The screws for the headlights are covered by the grille. At least on my 89 model they are. Do you have sealed headlight units or the unsealed ones you can...
  2. Replies
    0
    Views
    251

    Injector Pump Timing + Fuel Screw

    Hey guys, I did a bunch of searching around but I couldn't find an answer to this exactly. Feel free to smack me over the back of the head and show me if you know of a thread though.

    I have an...
  3. Replies
    0
    Views
    311

    Td42 Lower thermostat housing

    Hey guys, like just about anyone else who has a TD42 my thermostat long bolt snapped. Not once, but bloody TWICE. First time was flush with the top of the lower housing, the second time was flush...
  4. Replies
    4
    Views
    549

    Well, I knew the noise was coming from the engine...

    Well, I knew the noise was coming from the engine bay, and was happening at a certain rev range. So I figured that revving the car while looking at the engine bay would help me find the source of the...
  5. Replies
    4
    Views
    549

    Sorry mate, I don't know the right term for it....

    Sorry mate, I don't know the right term for it. The equivalent of a throttle link on a petrol engine. You twist it to increase the revs. I will pull apart the turbo inlet and dump tomorrow and check...
  6. Replies
    4
    Views
    549

    Turbo wastegate buzzing noise.

    Hey guys,

    Full disclosure: I've only owned my GQ for 2 months, so I'm very green and learning as I go.

    Lately I have been noticing a buzzing noise from the engine bay while driving (usually...
  7. Replies
    14
    Views
    1,263

    Thanks for the help guys. I'll give her a clean...

    Thanks for the help guys. I'll give her a clean tomorrow and watch for the source of the leak. Is it enough to let her idle for a while? Or is it better to go for a drive and put some load on the...
  8. Replies
    14
    Views
    1,263

    GQ TD42 Diesel on Front Diff

    Hi there,

    While changing the engine oil the other day I found a little bit of fuel on the front diff (driver's side, on the pumpkin). After a bit more of a look around, it looks like it may be...
  9. Replies
    18
    Views
    2,465

    Hey guys, thanks for the replies. I have found...

    Hey guys, thanks for the replies.

    I have found that patrolapart are selling extended sway bar links for 2-3" lifted patrols. Would it be worth getting those and replacing all of the shorter links?...
  10. Replies
    18
    Views
    2,465

    Hey guys, thanks for the responses. I have...

    Hey guys, thanks for the responses.

    I have been doing some research, and apparently there is supposed to be a ball joint with a thread at the bottom. The car currently has a 2" lift, so is it...
  11. Replies
    18
    Views
    2,465

    I just checked the inside of the sway bar release...

    I just checked the inside of the sway bar release and it's kind of just hollowed out inside. Do you happen to know how the bolt is supposed to be fastened inside it?

    Is it safe to drive normally...
  12. Replies
    18
    Views
    2,465

    Hey AB, thanks for the quick response. Is...

    Hey AB, thanks for the quick response.

    Is there a specific bolt that should be in there? Or do I need to replace the whole sway bar link?
  13. Replies
    18
    Views
    2,465

    Factory sway bar disconnect issue

    Hey guys,

    So I'm really new to my GQ patrol (only got it last week). I noticed that mine has the factory rear sway bar disconnecy. Today I was playing around with it, and once activated I noticed...
  14. Replies
    6
    Views
    319

    New Member - Hello

    Hey guys,

    I have recently purchased a 1990 GQ Patrol. It is a TD42 silvertop with an aftermarket Denco turbo system. My goal is to do the majority of the work on the car myself, however I am...
Results 1 to 14 of 14