Are the 8 bent push rods all of one cycle? Like all the exhaust or all of the inlet or just one of the banks complet 8 push rods is bent?
Type: Posts; User: nissannewby
Are the 8 bent push rods all of one cycle? Like all the exhaust or all of the inlet or just one of the banks complet 8 push rods is bent?
Fixed.....
Use the stag. Make sure all surfaces are very clean. The other stuff that works well is the loctite hydraulic sealant. I use it a lot on all tapered fittings at work. Its a liquid and only requires a...
There are ways to neaten it up a lot. Throw a PLC and basic screen in and you can run say like 1 can bus cable to the rear to a slave that then can switch on accessories. This kind of stuff is cool...
The high pressure line will always be the smaller one. Everything after the steering box should be larger returning to the reservoir with basically no restriction. A cooler helps in that with a temp...
Yeah there is just to much flow returning to that little reservoir but it is only a thought. I know BD are fantastic are supplying secondhand crap
A standard shaft seal can usually only deal with very little pressure like 30psi or less. Unless a high pressure shaft seal is used. So the hose clamps will still hold on way after there is enough...
I don't want to seem like a prick but are you 100% it's plumbed up correctly? To blow the shaft seal means you are pressurising the case somehow. The shaft seal should basically never see pressure...
Small ports I think are used when EGR was fitted hence being black. Non EGR intake manifolds just don't have a port so it gets blanked off. I could be wrong here.
The small canisters. The one in...