The new injectors seem to have done the job. Running well again and I'm looking forward to seeing what performance gains or fuel consumption improvements are to be had.
Thanks again for for the...
Type: Posts; User: besp
The new injectors seem to have done the job. Running well again and I'm looking forward to seeing what performance gains or fuel consumption improvements are to be had.
Thanks again for for the...
That won't fix my problem!
I was just wondering if the failed injectors and plugs had any correlation. No reason I can see but thought the collective wisdom of the forum might!
I replaced the injectors today. Truck started up after a couple of long cranks and chucked out a ton of white smoke. It registered about 12000psi max. Didn't rev it or do anymore today as it was...
Thanks for the replies.
Mudski - Yep they are in the a workshop
a manual as a must replace. Several injection specialists I've spoken to say they should be ok to reuse if I'm careful not to...
Thanks HappyGU. Especially for going outside!
Sounds like you think I'm on the right track.
Only two seem to be leaking back a lot. I have ordered 4 as I guess the others will be on their way too...
Oh and on the last drive I got a P1089 (low fuel pump pressure)
Whilst troubleshooting I also got P0193 (fuel rail pressure sensor circuit high input) but I think that was just from when I pulled...
Evening fella's.
2008 3.0L Common Rail
1000km ago it started taking a half second longer cranking to start (put it down to the new battery being a lower cold crank capacity).
400km ago the...
Yes it's sitting a bit tight.
I'm researching a 2" lift right now!
Wheels and tyres on today.
285/75 on a 16 rim with neg 13.
Thanks for all the help.
http://www.nissanpatrol.com.au/forums/images/imported/2016/08/59.jpg...
Neg 13 looks right. Thanks threedogs.
Thank bud. Will report back!
I'm in Sydney.
Have only spoken to St Georges Tyres so far but now I know more about the offset I'll be hitting the phone.
Any recommendations?
So the tyre shop say that there's a possible cost of $90 if the wheel nuts from the current wheels don't suit the new ones.
Factory alloys to sunnies. Does this seem true? Anyone had this problem?...
Thanks for the pics guys.
Neither are shouting out to get pulled over.
Thanks guys. So neg twentysomething is not neededed for either big calipers or a wider 305 and might actually be an issue with adr's and protruding past the arches. So I think something around the...
Thanks abw.
Did you go neg 13 for a reason?
What year are you and ST or DX?
Would a another 10mm still keep within the guards?
Ta.
Sent from my LG-H815 using Tapatalk
Randwick NSW
Fitting my own snorkel.
Any particular type of silicone to use?
And how tight are the seals on the top of the airbox and the pipe joins between airbox and turbo - should i sticky these up too?
...
I have a 2008 GU6 with the 17inch factory alloys and 265/70/R17's (31inch)
I am looking for a 33inch equivalent.
It looks like a new 16x8 sunny with 285/75/R16's seems to be a well used combo and...
Dog crates! Plenty on eBay. Could be a good starting point.
Or they could be cut and used for a ventilation "window" in an existing mdf/ply box?
Thanks anyway threedogs.:thumbup:
Thanks katwoman ans mudski.
We're probably getting a 65l waeco. Taller than both of yours and side hinge rather than end hinge on the arb so I have a feeling this might be an issue.
I'll have to...
Sydney mate.
Good point Dr Gary.
Think I'll just make the plate!
I'm looking at these too and have the same question as juzzs8:
How far does the shelf extend past the front of the front of the drawers and does a fridge lid open clear of the truck roof?
...