OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Type: Posts; User: mudnut

Page 1 of 20 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    6
    Views
    196

    Welcome to the forum.

    Welcome to the forum.
  2. Looking forward to seeing the shots you get with...

    Looking forward to seeing the shots you get with the new camera.
  3. Replies
    14,114
    Views
    2,071,758

    Sticky: That is just the pits. I see grubs hauling...

    That is just the pits. I see grubs hauling trailer loads towards the forest quite often. I have found old bathroom interiors, complete with asbestos backing adhered to the tiles. Its heartbreaking....
  4. Glad to read your lenses are Ok. The Sigma is far...

    Glad to read your lenses are Ok. The Sigma is far too heavy, to be honest. I can only get a couple shots off when holding the camera, especially above chest height. It also has the annoying ability...
  5. No good at all. I thought you had a Pelican Case...

    No good at all. I thought you had a Pelican Case with silica to keep it dried out. Is the Sigma lens still serviceable, Cuppa?
  6. Thread: Introduction

    by mudnut
    Replies
    5
    Views
    138

    Welcome to the forum.

    Welcome to the forum.
  7. Bloody hell, Mark. You are having a bad trot. You...

    Bloody hell, Mark. You are having a bad trot. You need to go on holiday ASAP.
  8. Thread: Hey

    by mudnut
    Replies
    4
    Views
    173

    Welcome to the forum.

    Welcome to the forum.
  9. Thread: Welcone

    by mudnut
    Replies
    4
    Views
    104

    Welcome to the forum.

    Welcome to the forum.
  10. Replies
    15,903
    Views
    2,202,640

    Sticky: They say, if you love your job, you don't work a...

    They say, if you love your job, you don't work a day of your life! Enjoy the trip, Tony.
  11. Replies
    12
    Views
    329

    If it still carries on, then you will know that...

    If it still carries on, then you will know that its a wiring problem.

    Another way is to use a transistor to take away the main switching current from the points. Plenty of info on Google about it....
  12. Replies
    12
    Views
    329

    Dunno. Just conjecture at this point. According...

    Dunno. Just conjecture at this point. According to Pertronix their system is either good or bad. No in between.

    http://www.pertronix.com.au/troubleshooting.html

    One section on the Pertronix...
  13. Replies
    12
    Views
    329

    If it is a GT40R then it does need the resistor....

    If it is a GT40R then it does need the resistor. But is that compatible with the Pertronix? Maybe it needs a 12volt coil to function properly. Call Patrolapart and ask.
  14. Replies
    12
    Views
    329

    On the wiring diagram for 1988 models Haynes page...

    On the wiring diagram for 1988 models Haynes page 12-14. It shows that the red wires give the original coil a 12volt feed to start. If it was my vehicle, I would just leave them, just in case you...
  15. Replies
    12
    Views
    329

    I have read that the coils with an R in their...

    I have read that the coils with an R in their part number run on approximately 9volts and require ballast resistor. Those without an a R designation need 12volts to operate.(hopefully this can be...
  16. Thread: Depression

    by mudnut
    Replies
    1,073
    Views
    334,182

    Sticky: Sorry to read of your situation. You've got to...

    Sorry to read of your situation. You've got to look after yourself before you can look after anyone else. So glad you have a referal to a Psyc. They specialise where a GP has only a smattering of...
  17. Thread: Good day

    by mudnut
    Replies
    4
    Views
    94

    Welcome to the forum.

    Welcome to the forum.
  18. Replies
    6
    Views
    205

    Welcome to the forum.

    Welcome to the forum.
  19. Replies
    5
    Views
    142

    Welcome to the forum.

    Welcome to the forum.
  20. Replies
    5
    Views
    121

    Welcome to the forum.

    Welcome to the forum.
  21. Thread: New member

    by mudnut
    Replies
    4
    Views
    112

    Welcome to the forum.

    Welcome to the forum.
  22. Replies
    3
    Views
    251

    What condition was the fluid and how blocked was...

    What condition was the fluid and how blocked was the filter? Was there a burnt smell or a heap of clutch material deposited?
  23. Thread: Silo art tour.

    by mudnut
    Replies
    5
    Views
    375

    Warracknabeal is a picturesque little town. The...

    Warracknabeal is a picturesque little town. The locals have taken pride in their heritage. Young kids will love the albino wallabies in the creek side park.
  24. Thread: Silo art tour.

    by mudnut
    Replies
    5
    Views
    375

    Brim and Roseberry. Warracknabeal has a...

    Brim and Roseberry.

    Warracknabeal has a couple of statues of kelpies herding sheep, or sitting atop bags of wheat. There is also a nice park near the waterway with some birds and animals on...
  25. Thread: Silo art tour.

    by mudnut
    Replies
    5
    Views
    375

    One had a sign, saying it was used in the 2012-13...

    One had a sign, saying it was used in the 2012-13 season. Unknown which ones are being used currently or not. The Stick Shed was built during WW1 as emergency grain storage, until being shut in the...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4