Search:

It might be a thermo fan switch for the fan on the aircon condenser, some models it was a last resort to stop the motor overheating (on at 107 deg off at 105 deg) or it used to have aftermarket...

I have one fitted to my GQ, I use it for petrol and so far haven't had any dramas. The only time it has lost prime was when I ran out of fuel on main and switched it over at 100km/h, it just lost...

Found some...

http://i353.photobucket.com/albums/r400/bundyboy22/DSCF0496.jpg

http://i353.photobucket.com/albums/r400/bundyboy22/DSCF0497.jpg
...

No worries, I like the plans as they allow you to make the drawer runners, they are strong and allow a bit more flexibility in how far out they come. I will see if I can upload some photos of mine...

I found the link to his site for the plans. It is here..... http://4wdstuff.davejones.com.au/subdomain/4wdstuff/Other/construction_of_drawers.pdf

I am trying to upload the plans but it doesn't want to work, the file is 790kb but the limit is like 430kb and I can't get the file to compress enough or able to make the one document into two. I am...

I have some plans at home for rear drawers and fridge slide, when I get home tonight I will find them and upload them on here, they were designed for a hilux tub but the concept works well and are...

I have seen somewhere on the internet someone had removed the rear side windows, frame and all, fitted alloy checker plate on hinges with gas struts and locks, from memory it looked quite good and...

I think they just use the ryco one as it has the correct configuration and size for the patrol, as in it fits the bracket next to the battery, inlet in the bottom and 90 deg out let at the top. It...

I was going to buy genuine ones but ended up using the chair leg rubbers instead, I figure by the cost of genuine there are heaps of chair stoppers for the price.

So far I am very happy with them...

Yeah, I pulled the bracket out that held the jack in place and replaced it with that, I figured the standard jack wasn't going to lift the car so it had to go. The amp install kit works well, it is...

I'm pretty sure you can get the mast bit from Bursons or Super Cheap. The plastic bits that connect it to the body just slide off and the base of it unscrews. My old Patrol had a broken mast and I...

Here is a quick photo for you to have a look at. The fuse box is behind the panel, as it only has two bolts holding it on it is quick enough to take off and change the fuse.
...

I had a look last night after I posted this and found that the check valve that I didn't bother hooking up as the filler neck I got from the wrecker had an extra breather hose on it so I just hooked...

I put my mic on top of the centre part of the dash that way when I'm on the phone the passenger can talk aswell, it works on the GQ dash as it fits right beside the hazzard switch.

I have the AP50 kit in my patrol, it was fitted when I got it but have had to change the tailshaft sensor to be more suitable offroad. So far I haven't had any dramas with it.
The only thing I don't...

I have them in the back of my GQ, I got an amplifier wiring kit and ran the wires to the back where the jack sits, I pulled the inner bracket out and cut a replacement panel out of alloy sheet, it...

I have the pertronix kit fitted to mine with the extended rotor button and GT40R coil, so far it has not let me down. I changed the coil from an oil filled one to the epoxy one as the oil filled one...

I have a pair of Autotechnica seats in my patrol, they are comfy and used the factory rails and mounts, it just needed two pieces of 8mm flat joining the two halves of the base to mount the seat to....

Gday, I have just finished converting my patrol back to straight petrol.

Now I have a problem with the tanks pressurising, whenever I stop I have to open the fuel cap to let some of the pressure...

I have a mate who runs the new BF muddy tires and they started to wear real quick until about 75% now they aren't too bad, he did rip out a sidewall on a trip (the only person for the trip) I saw...

I've got a set of Bighorns in 33's, so far I can't fault them, they're good on road even in the wet, good on rocks and shale. Havn't done much in mud yet so can't judge yet.

This is from another forum but...

pulsar n12, n13 and maybe n14
pintara both r31 and u12
pintara TRX
ford corsair and corsair ghia (a pintara underneath)
skyline r31, (including TI and...

I have two on the middle section of the bull bar, they are a matched pair of ZCG ones, I still have good forward vision as does the passenger, never had any dramas with the police either.

Im from Victoria, originally from NSW but saw the light and moved, that and the weather is better here too.