Search:

when i turboed my td42 i put a tee piece on the oil presure sender and ran a braided line over the rocker cover to the turbo hope this helps

thats the one depends where u did your trade

Check the movement in the trunion bearings in your front hubs i tossed out the factory shims in mine ages ago to tighten them up havent had the dreaded nissan wheel wobble since

Watch the puller it can damage the rubber What ive done before is put the nut back on backwards(to protect the crank) and with a brass drift and a hammer hit the outer egde of the damper as its a...

just going through the dramas of a second hand td42t overheating in my my02 cab chassis just another case of me spending dollars to save cents.Heres what ive done to fix the prob. Changed coolant...

I hate people who dont pay attention to my pilot when im driving oversized loads when im up on ,y weights and people pay no attention it makes my blood boil

Just had the viscous hub die on mine so as an experiment i drove it home from Blackwater back to home with an eye on the temp gauge at a constant 100 kms it stayed at 105c only rising to 110c when...

id suspect the water pimp i replace mine every year

if you are removing the crank anyway why not just get the front where the damper sits built up and machined back to spec a cheaper option ive used many times on many occasions

The td 42 engine isnt an overly difficult engine to rebuild any reputable machine shop should be able to remove and replace the liners for you then its just a case of follow the workshop manual

known its been coming for a while now my sets got 120 programmable channels

Ive had a problem with my td42 running warm from new in a 02gu and occasionally running hot steps ive taken so far raised the rear of the bonnet 5/8 of an inch (some help) removed lh sensor from...

I would find the reverse light wire in the loom (check wire colour/number at bulb if need be) and splice into that wire .I would use this as a switching wire to a standard relay pin 85 or 86 as they...

Ive tried using 2 stroke oil in my fuel at various ratios back to back same runs etc. and found it made no difference to the fuel consumption over the time i used it the only thing different i found...

Being lazy at the moment and am wondering what the bolt pattern is on the Nissan bellhousing on its 5 speed or auto for that matter both should be similar as m planning an engine swap and am curious...

i was told that fusing both wires was to help protect the set if battery hookup was incorrect i always thought a diode would be easier

thanks for the information i knew it was out there somewhere

hi to all ive got an 02 cab chassis with a td42 engine with an aftermarket turbo numerous oil leaks and a gearbox about to let go (you know what they say about mechanics cars) lol glad to be a part...

Could be many things is injector pump timing out are injectors dirty is it a bad batch of fuel is the valve timing out slightly have fun with it

Just curious as to what is the highest ratio diffs Nissan put in the gu series. Ive got an 02 cabchassis with leave springs and am looking for something higher id like to stay with Nissan Parts if i...

ive wired both my uhfs direct to the battery through relays i used the switched wire from the cigarette lighter to power the relays when the ignition comes on i dont like them on when the keys out...