Get genuine mate, there only a few $$
Type: Posts; User: Diesel-Mate
Get genuine mate, there only a few $$
My local performance shop/exhaust shop. Iv got no mufflers but if I wanted them it would have been $100 more.
One of the best mods I did.
My 3" exhaust cost $760 fitted including dump with pyro bung. Its made out of 2mm steam pipe so will last a very long time. You want as little back pressure as possible with a turbo diesel.
I went from a 2" lift with 33s to a 4.5" lift and 35s and didn't tell the Misses. She's only 5' 3". She walked up to the GQ and the bonnet was way over her head. She noticed something had changed but...
34635
Here you go.
Rebuilt swivel hubs, installed new axles seals and now just waiting to get my diff centres back with the brand 4.6 gears installed!
I've got an auto lokka in the front with standard LSD in the rear. The lokka made a huge difference reducing the speed I could tackle obstacles. In sand I've noticed that there was an improvement in...
Hey mate I would remove the altitude compensator incause it is restricting your max fuel delivery thus reducing max power. Although the system may reduced smoke I still don't think that is a good...
Its $470 for my rego and around $600 for green slip
My Rego is $1100 for 12 months. Just because I'm under 25
Wow the rb30 must have been red linning it for that to happen. If your worried about that happening get an intercooler.
As long as you get the kit from a reliable seller that has strict quality control then you will be fine. The turbo is slightly laggy to get on full boost because the compressor side is so large. You...
Oh yeah my clutch was completly fine with the power upgrade and its old as the hills. So I wouldn't worry.
Mate it doubled the power of the old girl. Hills I used to have to drop back to third I can now cruise up in 5th, that much of a difference! Also I took the sump off and got a piece of stainless pipe...
Can we just take the tow ball out and use the pin to hold a snatch strap in?
Fitted a lift pump to help out with the fuel starvation issue under higher revs. It's a solid state 3-4 psi facet pump and it does its job quite well. It came with 1/8 ntp to 5/16 barb but the gq...
Sorry for the late reply my computer died.
This is the turbo and manifold I used.
http://item.mobileweb.ebay.com.au/viewitem?itemId=190786035472&index=1&nav=SEARCH&nid=81003886537
This is...
Also its 530mm from the center of the front wheel hub to the edge of the metal guard above.
The rear is 540mm and is measured the same way but on the rear of the car.
I'm running 15psi boost with the standard injector pump wound fully up. Just install your turbo and get the truck going. Once the truck is running smooth with no oil leaks ect then I would start...
Do you need help with your injector pump?
Yeah thanks mate, these aftermarket headlights I brought are meant to be designed for the hids but if they still scatter I will point them more at the ground or put them in my spotlights.
Also brought a HID conversion kit for my headlights of eBay for $100. Heres the link.
http://item.mobileweb.ebay.com.au/viewitem?itemId=251210893564&index=10&nav=SEARCH&nid=64834907696
And...
Got some bolt on rocks sliders made up for $450 from Patrol Customs in Beenleigh. Looks awesome.
Do you mean my injector pump or the electronic lift pump I fitted?
Yeah I agree with the sizes being different between brands. My 33" bighorns measured the same as some 35" tires