Search:

Thanks, I got 26mm ring spanner and was able to remove sensor, not that hard. I need to remove starter bolt with 14mm spanner and it will be all ready. If you could remember what VDO adopter did you...

Hi, I had look and just wandering how did yo get spanner to that sensor location as from my assessment it look extremely hard. I replaced oil and filter already and the sensor is at higher position...

Thanks for your help. Did you have to drain oil from engine before removing that sensor to fit T connector? Also my car is 2003 model and not CRD, I will have a look how easy to do it. I have new...

Hi, I would Like to install oil pressure gauge on my zd30 engine. What is recommend spot, I read that properly it should be on right side near starter but also on forum there are advice left side...

Hi, I have white/grey smoke on cold start on my 2003 ZD30 Patrol, and it clears after a couple hundred meters of drive. Water tank is full of green coolant and does not change in level. When engine...

Good to hear that your almost unmodifed track has done so many km. What year is it?

Thanks for help. How much maximum boost you had when EGR was blocked.

Hi everyone, I am new to this forum and recently bought GU iii with low km, less than 140k. I want to block EGR as it has not been done before. Could it be done without installing mechanical boost...

Where to get full Patrol gu3 instruction manual online? Thanks