In the manual it's referred as an ignition relay.
But anyway there has not been a miss-start since the swap. I have a new one coming.
cheers and thankyou for the advice.
Type: Posts; User: robewott
In the manual it's referred as an ignition relay.
But anyway there has not been a miss-start since the swap. I have a new one coming.
cheers and thankyou for the advice.
Just did that & it went first go however that happens as well. I'll try early tomorrow & see if it fixes it. Will a start relay fill in that slot?
I have a problem with starting my ute mostly in the morning but it can happen any time of the day. When i turn the key on the engine & glow plug light do not come on - no start. After turning the ...
I've put another oil pump into my cr patrol & after putting it back together it would not start. So i've pulled the timing cover off again to make sure the timing was ok. It all lines up with the...
hello, is there a machine that can do full component diagnostics for a patrol crd ute 12/07 other than a dealers consult 2. My car has an obd2 plug. I have had a loan of an autel ds708 but it is not...
apart from the the head gasket on the exhaust side, what other gaskets will i need after pulling off the manifold? Can the turbo unit be pulled to one side while the ex gasket is replaced?
It's only there when the engine is cold. It sounds like the exhaust manifold.
If you need an injector, buy it off ebay not from the repair shop. They charged me $800(+$700 labour) for mine & i bought a spare one off feebay a month later for $250......crinamal!!!
mine is 130 psi key on. 1600- cranking, 5000psi @ idle, at 110k/h its 20000+. I've had a similar problem about 60000k ago. they put in a complete rail in for a squillion dollars.
If an injector is...
What i'm wondering is how much extra diesel has to be sqirted in to compensate for less oxygen to burn, to get the same power.
Thankyou for that. I haven't seen that welder before.how long would the 24v setup last ie how many 2.5mm rods?
i'm not to sure if this fits here. Has anybody fitted a unipower welder(south african) to any 4wd? It involves putting on a high powered altenator to run it.
if anyone has done it, how good are...
I've got a high pitched squeal in mine somewhere around the turbo/manifold.
Just say i'm going down the highway at 100k/h in a stock standard patrol crd. What is the combustion mix of a) atmosphere b) exhaust gas c) sump oil, on one cylinder?
after reading the SAF bio again, it carries 4% more fuel(182L)
Wandering around the net a couple of days ago, i ended up at the south african patrol site. Their patrol has 110kw as to our(aust) 118kw. Their distance for both tanks of fuel was quoted at 1600K,...
I tried to call but no luck & have sent an email. At least they give prices on the port repair. Will wait and see.
I have a GME uhf for work. It sits in a cradle on my back pack. I have a Wilson booster/amplifier on my mobile which allows me to connect to the internet. The mobile tower is 60k away.
My satphone...
i got one of those bloody overseas call centers and he would not offer one repair shop. I emailed magellan 2 days ago & have not heard back. Jaycar sounds like a good idea. Surely it can't cost $600...
i thought a ute would be heavier. There is quite a lot of thicker metal in the tray.
I have a magellan explorist 710. I use the bike to power the gps through the usb port & after a couple of big prangs, no longer works. I rang magellan & the with unit being out of warranty, they...
Is that wagon or ute? If it's the former, what does a st zd30 ute(with tray) weight?
I've seen one mounted on a heavy duty trailer for a mobile workshop & you could get under the car.Just drive the vehicle onto the trailer & away you go. That set up looked pretty good. I was just...
Does anyone own one of these? It looks to be extremely unstable and unsafe. Maybe mounted on a trailer would be ok.
...
the evil green bit has missed me by about 5 miles, not unhappy about that. My work has all of the above but i get as far from the salty water as i can