got the uhf... from perth arrived lunch time,
Printable View
got the uhf... from perth arrived lunch time,
uhf is fitted.
the wife just complained the front doors make too much noise and a too hard to move. anyone say new door hinges :P
swapped the old 100 w hella's for a aurora style 20" light bar.
trying out a thing similar to g70. but a ceramic not ptfe.
nice work!
yep thrust bearing Attachment 72526
Attachment 72527 yep a nissan clutch in my ford. over 500 000km on that one.
Attachment 72528 box and transfer out.
Attachment 72529 new bits ready for the box.
been a little while since i've done much on the mav, knocked up a box for the sub and a couple speakers with an amp to go under the back seat. just need a couple bits and i can fit it in.
got the box wired up well nearly. but i do have doof doof. will be running 6 speakers and a sub. might even drown out that annoying noise in the back seat...
found the bash plate under the fuel tank was loose. that bolt came out got cleaned up and locktited then tightened till it held everything from moving. this required one foot on the rear bar using a short breaker bar....
got around to replacing the bailey channel. in the drivers door. just need to trim the door card to fit speaker surround. and i should be done pulling it apart till i do hinges