This Autoglym Bumper and trim Gel is the ducks nuts for bumpers/snorkels etc. http://www.supercheapauto.com.au/Pro...l-325mL/383925
Printable View
This Autoglym Bumper and trim Gel is the ducks nuts for bumpers/snorkels etc. http://www.supercheapauto.com.au/Pro...l-325mL/383925
I'll give it a go on your recommendation tomorrow on the way back from the Docs
made a bracket to hold the air intake ducting so it doesn't rub on the alternator.
applied some perforated black window film to the inside cargo window
on the passenger side, it will be done in 2 pieces but will be un detectable
when finished. should allow the fridge to work a bit more efficiently lol
Finished the storage for beside fridge , hardwired thumper max in behind storage slide out box and wired switch to centre console .
Have put a ball valve in between pump and inflator so I can check how pressure is going without having to turn pump off .
Attachment 71189Attachment 71190Attachment 71191Attachment 71192Attachment 71193
Good to see you have the photos up the right way around, if fitting a tank
I'd be fitting a one way valve to stop the pressure releasing back through
the compressor, Good value those pumps, I have one pump that cost me $600 plus
from Big Balls Off Road, not even close to my single headed Thumper
Thanks threedogs , to be honest now I've tried it out with the ball valve on the inflator I'm impressed as to how good these pumps really are .
May put a tank on it and a line under roof rack both sides , just open sliding window and connect short hose to supply air from compressor.
Love they way it cuts out by itself at 150 psi and restarts at just under 100 psi , it's amazing to hear the air rush in just from the line .
Might do some investigating to see if I can set it up like a servo , ie set to 16 psi it automatically lowers pressure , set to 40 it automatically sets to that then cuts out .
More than happy with it and now the pumps fixed in position out of the way and hard wired so the only mucking around is the hose .