What did you chose for the new instruments (assuming the new senders are for new ones)?
Printable View
What did you chose for the new instruments (assuming the new senders are for new ones)?
Attachment 87885
one coolant overflow bottle .
Attachment 87887
can anyone guess what this is for ?
A huge caryall donut [emoji507] tray for bait Old Mate [emoji51]
My honest apologies for sounding nasty and do love your work [emoji736][emoji106]
Genuinely concerned though about firewall issues of flex & impact between the mounting extremities, hopefully I’m just being a worry wart [emoji1696]
Not sure what brand your stainless 4” clamps on your Beaut air intake system are too? I had bought similar looking, anti-seize sticked every single one during installation on my setup and still found over 50% were galled, so deliberately replaced the entire lot for future maintenance ease [emoji51]
Sent from my iPhone using Tapatalk
https://www.normagroup.com/norma/en/...pen&ccm=020030
Sent from my iPhone using Tapatalk
A lot of engineering/crumple zone testing, I am assuming went into this design Garret Old Mate [emoji120][emoji3590]
https://www.nissanpatrol.com.au/foru...2024/03/55.jpg
Please do consider [emoji120][emoji120][emoji3590][emoji3590]
Sent from my iPhone using Tapatalk
Garrett, I think the load on the very small steel sections will let you down. There isn't much deflection strength in this assy, the welds at the RHS to Angle interface will fatigue very early. The frame is going to be subject to every vertical motion and I will say its a great concept but ultimately wont last the distance. Anyway give it a whirl I guess but I hope it does not come adrift in some awkward location and do further damage.
I got no idea what it is just yet but @MB I don’t see much impact strength in that flat bar section.
What the deuce is it anyway Garrett?