Search:

Did you grease the races?
also the rollers may have a flat spot which is now else where.
I had no drama removing or replacing my king pin bearing cariers as I supported the axel on stands removed...

Nah, no apologies required. I understand the frustration. I'm also partial to some verbal ("textual" sounds rude) sparring. And that bag of popcorn... Oh lord, I need it now!

That's cool. I'm getting a lot of comments like yours (and it is definitely appreciated). It's the flip side of wailing doom that worries me. Though I suspect you may be right - those professing the...

Quick warning if you tighten the screw on the steering box make sure the wheels are straight ahead or you will find it jams when returning to straight ahead
It always must have a wisker of free play...

You need to take the mirror off, pull small plastic trim piece off from inside of door
undo screws that hold mirror onto door undo screw that holds plastic cap under pivot point of mirror
inside it...

Yeah there is a slight Wobble but not noticeable whilst Driving

There is a Phillips Head Screw on the Base of the Mirror

http://www.nissanpatrol.com.au/forums/images/imported/2015/10/215.jpg

Hi
yes i have seen these videos and all is good with the truck at present.
Thanks for the info.

Mrs H

I will be so disappointed if the work i am having done doesn't fix my problem. Reckon i will cry as its driving me nuts. Ok to drive around town but the highway is murder. Well the Truck is waiting...

Hi all
Nothing to report sorry to say. Other things have taken priorities this last week or so but Friday it is. Was pretty good until this week after i had the steering adjusted but its started...

Well there you go - a few hours in the garage today, removed the shims of both front wheels, and wallah -no more wobbles.
Still a slight vibration right through the speed range, so in for a balance...

I still can't find that image but this will help.

Looking at the pic i reckon i wont fit. On mine theres a cut out section on the end where the tank sits around the right hand top control arm. Plus you need bent upper control arm fitted too. So it...

The chassis is the same TD

Hay. For 80 bucks. It's worth the punt. Good luck mate hope you can squeeze it in.

Ive heard the same things as others that the gq aux wont fit unfortunately. If it does however it will be interesting to know as I'm constantly keeping my eyes of and all i see is gq tanks....

Chassis are the same but bodies are different.. pretty sure there is a height issue when fitting the gq tank to a gu

Sent from my SM-G800Y using Tapatalk

Was it off a gq?

I don't think a gq aux tank will fit in the gu unfortunately mate.

Don't quote me but I remember reading about this many moons ago from someone else who tried.

Anyone?

Looks exactly the same as my lra gq tank. Not sure if it'll fit the gu

Sent from my SM-G800Y using Tapatalk

Thanks Peter,
The pipe was delivered this morning.
I see what you mean about the clamps.
I replaced the originals a while back with some stainless ones, and will use them.
Thanks again for the...

2003 would be a direct injection unless its had a motor swap. CRD didn't come in until 2006 ish I think.

This pic shows the position of the Mass Air Flow sensor (on my ZD30) on the top of the air filter housing. Shown here with the wiring cover removed....