a TB45 is a good strong work horse - not quick, but reliable - 430K is mid life for average use (if its been babied - young / if its been thrashed - old.......)
get good quality Gas plugs (if you...
a TB45 is a good strong work horse - not quick, but reliable - 430K is mid life for average use (if its been babied - young / if its been thrashed - old.......)
get good quality Gas plugs (if you...
Hard to say.
If I were ever to do it again I would pick up a diner car complete just for all of the bits and bobs.
There is just so many little things that all add up in the end. Also the...
your best bet would be to pickup a GQ with the TD42 in it, take what parts you need
engine / fuel lines / wiring harness
flog the rest off
buy a 2nd hand fuel tank from a wrecker
give yourself a...
Check all the pulleys where the belts run. Probably best to remove the belts and have a feel of every pulley wheel.
Sent from my SM-P600 using Tapatalk
Some wreckers will sell the engine plus all bolts needed for a conversion. Well most when i was doing my conversion wouldnt sell me anything as they keep it all for their own kits they sell.
From...
I paid $6800 for a Jap import factory turbo engine and spent another $3k on new parts like seals, hoses, gaskets, studs, water pump, etc.
Had to buy new alternator & starter because the engine was...
Ow shit.. change it asap..
That's way to much difference in diameter and you'll distroy your lsd..
If you can't fix it asap stick the spare on the front and do not lock the hubs..
Not sure how the...
If you have an LSD then that is too big a difference in tyre dia, get it sorted asap
If you have an open diff and diff lock - Check the wheel nut tension... bit hard to describe but a few loose...
Hi Guys, i recently put a new radio in my Patrol and couldn't find a wiring diagram anywhere so i decided to make one so if anyone needs it is redily available to you! So here it is:
Hi Guys, i recently put a new radio in my Patrol and couldn't find a wiring diagram anywhere so i decided to make one so if anyone needs it is redily available to you! So here it is:
Prime, KillRust and or paint the cut. put the trim around the cut and silicone the outer trim to ensure no water can get in.
...
There is a lot of information to put in here so this post/thread will keep growing over time, I'll add photos as I can.
This is by no means a complete or definitive guide, my aim is to give people...