OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 1 of 3 1 2 3

Search: Search took 1.00 seconds.

  1. Replies
    3
    Views
    1,058

    Yeah - ha ha. Plain english, aussie bloke/shed...

    Yeah - ha ha.
    Plain english, aussie bloke/shed method.

    On the end of the hose that goes from the fuel filter to the engine, temporarily fit a 3/8" (8mm) brass tee and an extra bit of fuel hose...
  2. Replies
    15
    Views
    5,507

    Thanks - your instructions are easy to follow and...

    Thanks - your instructions are easy to follow and the fit-up is very simple

    I run something similar using a 5 pin relay.
    The park light power goes to the centre pin, the reverse/camp floodlight...
  3. Replies
    14
    Views
    655

    All sorts of screams will come from what I'm...

    All sorts of screams will come from what I'm about to say..........

    "Use sump oil, and turn the chain oiler up full"

    Sump oil (engine oil) contains detergents. Plenty of oil helps the cut and...
  4. Replies
    25
    Views
    845

    Yeah - but they post a lookout.................

    Yeah - but they post a lookout.............. "CAAR, CAAR! "

    Trouble is they still get cleaned up by trucks and motorbikes.

    As far as roos go, the best way to avoid hitting them is not to have...
  5. Replies
    6
    Views
    1,173

    You realise the headlights in a GQ are earth...

    You realise the headlights in a GQ are earth switched.
    That means the "normal" earth lead runs 12v power through the fuses, and the leads for low beam and high beam are earths through the column...
  6. Replies
    9
    Views
    1,331

    Have use moly grease in the slide pins for years...

    Have use moly grease in the slide pins for years (cv joint grease). Doesn't seem to bother the rubber pin seals
    Tried silicone grease once and they gummed up before the next oil change - silicone...
  7. Replies
    1
    Views
    1,206

    To clear TB42E ecu, remove battery terminals, and...

    To clear TB42E ecu, remove battery terminals, and put the terminals together to discharge any current left in the system.
  8. Good to clean out the threads in the block with a...

    Good to clean out the threads in the block with a thread tap if you've got one. Surprising how cruddy they get.
    Remember to make sure there is nothing (grease. oil, crud, gasket debris) in the...
  9. By the look of it Crusty, it's surplus to your...

    By the look of it Crusty, it's surplus to your needs.
    It's an electrical controlled vacuum solenoid. Could be for a dozen different uses including your suggestion for the vapour cannister.
  10. Replies
    15
    Views
    5,876

    With the colder months, the tyres park up warm...

    With the colder months, the tyres park up warm and cool overnight. So where tha tread sits on the ground the nylon of the plies and the compound can "set" a flat spot.
    The colder the temperature and...
  11. Replies
    15
    Views
    3,674

    Crossed plug leads - check your firing order.

    Crossed plug leads - check your firing order.
  12. Replies
    5
    Views
    1,118

    I've checked this out (in theory) A commodore...

    I've checked this out (in theory)
    A commodore external pump puts out sufficient flow and pressure to run the TB42E
    Divert the wiring to it and you would have to put a bit of fuel hose in place of...
  13. Replies
    496
    Views
    235,321

    See the little washer nozzle above the clearance...

    See the little washer nozzle above the clearance light ??
    When cyclists piss me off, .......... I piss on them !
    83645
    83644
  14. Replies
    14
    Views
    3,939

    When out bush with poor radio signal (am/fm),...

    When out bush with poor radio signal (am/fm), knock a tent peg into the ground and pour a billy of water over it.
    Hook a jump wire between the radio aerial base and the tent peg.
    Works brilliant...
  15. Replies
    14
    Views
    3,939

    Good one Plas. Always done similar using the...

    Good one Plas.
    Always done similar using the wheel brace or breaker bar under the tyre.
  16. Replies
    26
    Views
    8,548

    A bit more work, but mount them in the bullbar...

    A bit more work, but mount them in the bullbar like this
    http://www.nissanpatrol.com.au/forums/showthread.php?45945-Replacing-headlights-GQ&p=795339&viewfull=1#post795339
  17. Replies
    26
    Views
    8,548

    I'm running 35w 3000k hid's in 2.5 inch projector...

    I'm running 35w 3000k hid's in 2.5 inch projector lights, mounted in the bullbar. Going up over Hotham at night in cloud/blizzard when I first fitted them , turned them on and the headlights off =...
  18. Replies
    8
    Views
    1,987

    From the old bloke down the street who used to...

    From the old bloke down the street who used to wake up the neighborhood with his night screams,
    The gentle "uncle" who couldn't have kids because of his treatment in POW camps, but would have been...
  19. Replies
    118
    Views
    32,463

    One of my favourites was already posted on this...

    One of my favourites was already posted on this thread "The Coachman's Yarn" by E.J. Brady
    ...
  20. Replies
    118
    Views
    32,463

    RIP Bob. Here's one for when you get to heaven....

    RIP Bob.
    Here's one for when you get to heaven.

    BRAWLING IN THE NAME OF GOD

    I was at a church convention
    sitting quietly on my seat
    As I listened quite intently to the throng
    For their...
  21. OK = basics. Y61 is a front beam axle, so other...

    OK = basics.
    Y61 is a front beam axle, so other than toe in, there is no other adjustment done for a wheel alignment. (Unless you change castor bushes or add drop boxes etc, the only way to adjust...
  22. Replies
    383
    Views
    93,707

    Bush used to be so open and clear under the gums,...

    Bush used to be so open and clear under the gums, that I'd chase roos and wallabies riding my push bike (single speed 28" with backpedal brakes) across the forest floor.

    Same bush today you...
  23. Replies
    383
    Views
    93,707

    My parent's couldn't afford sliced bread. Mum was...

    My parent's couldn't afford sliced bread. Mum was bloody particular too - had to be sliced perfect - old high top loaves.... my job among many.

    With reference to the fires at the moment, as...
  24. Replies
    17
    Views
    8,377

    This is an old problem with our standard 55/60w...

    This is an old problem with our standard 55/60w sealed beams on poor wiring feeding through a string of terminals, connectors and switches.

    Went down the path of Double reflector Hella semi...
  25. Replies
    4
    Views
    2,586

    Do you have a tank of stale fuel ?

    Do you have a tank of stale fuel ?
Results 1 to 25 of 56
Page 1 of 3 1 2 3