Search:

Ontrack 4x4 Fabrications in Neerabup. Pretty sure they do or have done engine conversions.

Like Ive said a few times which may suit your needs I use a Icom 400 or something like that with a remote handpiece,
I ordered a RJ55 patch cord so I could fit the mike nearer the passenger side, By...

We've got a 2002 grenade and have replaced tensioner twice but never noticed a voltage drop, replaced alternator because the clutch was seizing up , I was told the wires to alternator do get dickie .

Yes, that is OK

13.8 at idle is the minimum anything below that is bad.
14.2 at high idle and above is OK

Wow! You spent so much trying to find the issue and it was the chip?! Wonder what Dtronic would have to say about it...

Heres a list of the codes....
0087 Fuel Rail System (Pressure too low)...

Depends on how much off roading its done.

Really would GU body mounts be flogged out already
Long time between posts Fenda lol

Check that the lhf panhard rod nut is done up super tight. I had a similar clunk which went away after loosening and retightening the panhard nut.

The 1st row body mounts are about 40mm in height new, 2nd row body mounts are about 45mm in height new, the 3rd and 4th row mounts are about 48mm in height new. Check this against yours.

also maybe check the shocks rubber bushes if you cant find anything else

With modern electronics they should both read the same especially as they are both getting their signal from the ECU.
The gauge would be the most likely to be incorrect, probably something on its...

Or body mounts.... but not n this case lol

Like i said.... nearly always radius arms.

have you checked the CVs


Sent from my iPhone using Tapatalk

Grab some weld on washers from threedogs.
You'll need 8 and 4 new m16 grade 8.8 bolts 110mm long preferably in a metric fine thread..
Remove bolt, insert a washer either side, tighten and the weld...

Bit hard 2 see in the pic but the bolt holes on the diff bracket are elongated, like Kallen has suggested

64626

Radius arms for sure..
It'll be the bolt connection point to the diff..
Jump under the car with someone really bouncing the front up and down.

This link arrived in my mailbox. Possibly old news - but thought I’d share it for the benefit of those of you who like driving at night.
...

Being non-smokers we decided to get rid of the ashtray and it turned out to be a good place to put the voltmeter and a few switches. Used ply as the base (which was a mistake as it chipped easily)...

So I have now got my camper. So far so good, although a few hiccups on day one
1. Arrived at 0900 to pick it up as I had to go get it registered first, So picked up the paperwork, signed the rest of...

Maybe Check all external drive in first?
Uni joints especially.

Had the exact issue with our 2000 gu work car and unfortunately it was the flywheel. Hopefully others can give alternative things to check?

G'day Andrew,

The great thing about this trip is it a Long way for everyone. Growler and Westy are the closest by a long shot. This will be a great trip for everyone and a load of fun for sure...

Nizzbits is generally cheaper than any dealer. Or alternatively any performance shop thats sells silicone hoses to suit inter cooler setups would be the cheapest.

Hi All, forgot to give everyone an update!!!

Back home now obviously and the merchandise will be ready this week on Thursday.

I will pack them all up this weekend and send them out early next...