Search:

I think i have a full set under the house - im in Baulkham Hills Sydney if interested PM Me

Try ZD warriors(FB).

If not cheap and local, I would not bother and go buy a new sys.

I have a muffler delete pipe for 4WDSupacenter Dominator 8r SS 3" and the second pipe/flex joint...

Good looking Trol.

super nice your patrol.
I like the bumper

on a right hand drive car look in the lefts side of the passenger foot well

Sounds like your on a good track now, the kick panel is in the left hand side of the left hand front foot well.
You’ll have the pull up the scuff trim and then pull out the kick trim, there’s a...

On the pic you posted... Plug A is the plug in question and one of the wires will be labelled Rev Cam or similar.
If you put 12 Volts on that wire it will trigger the Head Unit to display the...

Hi Salim, try now mate....

Yes... or at least insulate the Head Unit end.

Personally, I would find out which wire is teh Rev Cam Trigger on the head unit and connect it up.

What brand/model is teh head unit?

if you do need a reverse signal for the head unit these is a yellow wire in the left hand kick panel that i used to trigger the head unit.
im sure is was a solid yellow wire just use a test light...

Yep... agree with you and Fireblade

I have found orange, purple and blue/grey at various times but no doubt there are Manuf using others as well... and if it is orange there are usually more than...

Different manufacturers don't follow a common wire colour code. So you really need to find a diagram as Fireblade posted.

Ok if its engine it may just be the injector pump. not knowing the sound and how loud it is makes it a bit hard to guess though. It could also be the rockers not getting enough oil maybe. I doubt its...

Where does it sound like the noise is coming from, under the car or engine bay? If you rev without putting it into gear does it still rattle? Manual or auto trans? Try putting into first and letting...

Salim, some pics of steps, quick dust off after 10yrs in the shed. Posted here as my dumb phone would have gone into overload.

PM me back with response mate.

PM'd U Salim

Worth considering ‘40NB pipe’ bought or homemade ‘sliders’ Salim mate!
It may seem a bit over the top at your moment but down the track eventually your GU heavy beast truck lower sills will surely...

Welcome aboard Salim mate!


Sent from my iPhone using Tapatalk

Welcome to the forum..enjoy

Sent from my SM-G930F using Tapatalk

Welcome to the forum mate.

Welcome to the forum mate and feel free to ask any questions.

start a build thread in Members Ride section then we all as well as your self follow
you build. to easy, personally I fit that lightbar under the bull bar to keep you safe from Mr P Plod
Sit very...

Most high flow cats will probable have one but check when you buy it.
easy to fit an EGT gauge.

"EGT Bung"... adapter for an Exhaust Gas Temp probe... much better to do before the exhaust goes in rather than after

Hello and welcome to the forum, ask away no silly questions here.
any pics of the Beast?? most of all enjoy