G.day, brw1994. Another problem would be moisture build up in the rocksliders. It could cause them to rust from the inside out. As for welding them without "pressure vessel certification', I doubt...
G.day, brw1994. Another problem would be moisture build up in the rocksliders. It could cause them to rust from the inside out. As for welding them without "pressure vessel certification', I doubt...
Easy as pie mate,
Pull cable out, attach to nearest bogged toyota, Spool in, Enjoy the lols. :D
Check for Voltage at the light itself 0Volts is Off, and 12V is ON.
You may have a broken door switch, and I would check both the rear doors first ( especially the big rear door ), and then open...
If your keen on the 24v then you will need a 24v system on the car. If your happy to run 3 batteries (which you will need to) then leave the cranking battery in the engine bay for 12v and then fit a...
Picked it up for $650 with free delivery.
Ask one of the locals for tips on how ti hide them!
so far so good on motorculture
Either you can't read or the tattooist was drunk,
That there be tigers partner, Here I'll show you the difference!!!
This is bamboo...
Here's another for ya growlers. Soak it up
And just for you Jonny
30711
30712
Thought of you mate while loading my ice covered trailer on....
30710
Like going to a car wash with under body wash.
Why do you guys have to life so far away?
Kallen Westbrook
Owner of
Westy's Accessories
Money, because I can buy things with it.
To be honest mate I think you are trying WAY TOO HARD. Take the academic hat off and this becomes a simple discussion.
You went to allot of trouble to alter your speedo reading. Very few, if...
For a GQ this is a good mounting system, I had 12mm laser cut with holes in each corner that were tapped to 1/2" unc.
then I had more plates cut to match the one I welded to the chassis, bolt them...
Drill and use pops to pull most of dent out minimum bog,
Then make yourself some sliders
With the engine running, on one side of the resistor you should see about 12 volts on the other side of the resistor you will see the 8 volts. At the positive side of the coil you will also see 8...
Thought i might as well start a diy thread on the spartan locker install.
I decided to buy a spartan locker from...
I have just built some bolt-on sliders for my GU wagon.
My sliders sit just off the bodywork and are similar in height to the chassis rails. This allows a little flex and protection.
They are...
My mate made this and put it on facebook. Thought it was worth posting here. Made me laugh.
http://www.youtube.com/watch?feature=player_embedded&v=jlQMOaB_BP8
Trick I Learned at work was to spray the pipe and the bender with loads of wd40 so it slides smoother, and won't kink as badly
Cheers!
Ok, bit different on a 4x4 forum but I posted this in the caravan forum so people would know how to silicone their benchtops to the wall instead of the silly strip that is there to start off with....
http://www.nissanpatrol.com.au/forums/images/imported/2011/04/1.jpgA nutsert works on the same principal as a pop rivet.
...
What is EGR (Exhaust Gas Recirculation) and why should I block it?
Wiki link for in-depth explanation.
TLDR;
*EGR works by recirculating a portion of an engine's exhaust gas back to the...