Yep
>>>tappin from tassie
Yep
>>>tappin from tassie
How's this?http://www.nissanpatrol.com.au/forums/images/imported/2016/02/139.jpghttp://www.nissanpatrol.com.au/forums/images/imported/2016/02/140.jpg
>>>tappin from tassie
I'll have a closer look in the morning mate, getting dark now
>>>tappin from tassie
A time saver is to set both the TC and flexplate to 6 o'clock before mating engine and trans
Rotate the engine to line a bolt hole up then rotate it as one to get the others in.
No idea! Lol. The tps is the black box with the rubber elbow boot.
>>>tappin from tassie
At the front of the carby, lower down. (this picture went sideways)
tappin from tassie
http://www.nissanpatrol.com.au/forums/images/imported/2016/01/163.jpg
tappin from tassie
Sorry got caught up on the new car..
So the short line goes on top and to the clutch
Long one under it and to brake booster..
In next to the fuel filter they cross...
Here is a couple of better pics of the fuel filter mounted above the fuel pump for your interest.
http://www.nissanpatrol.com.au/forums/images/imported/2016/01/98.jpg
...
Do these show you. You can just make out where they clip to the left of the air con penetration
http://www.nissanpatrol.com.au/forums/images/imported/2016/01/96.jpg
...
Sure. There is just sooo much plumbing running across the fire wall which is doubled up and not required.
Note also it was in my way as this is the airbox going in...
...
Note that your fuel lines cross over from the drivers side to your primer filter then straight back over again. Dumb design. I have also mounted that on the drivers side and removed the excess fuel...
Ok mime ain't stock but it's pretty close..
The bracket sits on the shock bulge and the canister in front of the fuel filter..
But.
I've relocated my canister to under the fuel filter to allow a...
Any turbo setup of any kind on a TD42 will have some benefit from using an electric fuel pump
Some people run lift pumps when running higher horsepower setups.
Leave the lines and tanks.
Is there an EFI fuel filter in the chassis like the TB45? If so, remove it.
I also had to remove the unleaded fuel restrictors in the fuel tank filler necks.
Do you have...
Yea leave fuel lines.. some people leave the tanks to..
You can use the TB lines :)
What is the trans already in the car? If it is the RE4R03A trans it will marry nicely to the TD42. But you say you also have a safari auto - which is the RE4R03A. Keep in mind that if it has come out...
Water will come from the coolant drain plug. You can put the return in the thermostat housing using a t where the heater hose returns.
Yes, that's the drain plug for the block. It's 1/4 BSPT thread.
Your other option is to put T pieces in your 2 heater hoses.
Factory turbo engine has these fittings
...
is it a 3/8th bsp hose barb?
further to the right at the bottom of your first pic. Hard to see on this broken phone screen.
It's not in the pic though.
Have a good look at the back bottom left hand side of your block
If, like me, you don't have the budget for Cross Country or HPD stuff, you have the option of the chinese ICs.
I bought a 450 x 300 x 76 (core size) bar & plate IC from Ebay for $159. I made my own...