Search:

All done finally....

I don't have a clutch so I guess I'll just blank that one off..

Hi had a major issue computer crashed with all my photos of the donor car being stripped, so now im stuck remembering where the bundy tubing from the filter exactly runs across the firewall and the...

Oh well at last something sorted Im keeping my pump body but with all the 11mm plunger and Boost compensator etc added to it, all done for $800, I thought that was pretty good. I now have all the...

61170 Hi Ash is this the bolt...

Nice setup jff45...

The special timing tool what does it look like and why 0.76mm @TDC

Nice.......

Hi what about TB42E ?

Finally car all sorted all the above inclusive of a faulty MAF sensor, so much torque now it lifts the front wheels on take off. Hopefully a good weekend for putting the boat in the water.

Everything was on the bench throughly cleaned or replaced, passed the miss it runs like a sports car it hammers along.

Yes definitely no leaks, still have original dizzy cap and rotor button.

We had a noise coming from the centre of the Maverick that got quite bad thought it was a handbrake issue, but was found to be a seized Uni joint on the tail shaft. Convinced it was the brake, the...

The Pajero seats can be locked so as to perform like normal seats in off road conditions.

Just had an idea to have an under bonnet lamp so screwed light bar to underside of the bonnet (mounted on rubber) Hooked 12v through a relay with a pull on switch in the engine bay. Been caught out...

We move 2 large boats around and the driveway is quite steep with an awkward dog leg, also a few of the ramps when crowded are easily negotiated when pushing.

Hi Parksy, tb42 basic coil and tb42e module type

It was when I dropped the tank and pulled the sender unit, I noticed that the float was still above the pickup by quite a bit when it was hanging so I measured lengths as if installed and checked the...

When I pulled the sender unit out of my Maverick I found that float arm was short and showing empty 60mm above the base of the tank, so have lengthened it to show empty 15mm from the tank base. In my...

pics of the twin piston callipers and new slotted rotors fitted to the Maverick

Okay started the brake swap, removed the Patrol Twin calliper and Rotor first I pulled the wheel first followed by the Auto hub carefully removing not to disturb the hub innards. Then disconnecting...

Had a crazy weekend so have not started them yet but will this week.

Yes it would be tight Damaverick has 15" rims I have changed mine to 17" which appears to have ample clearance.

That's made my mind up to keep the manual hubs and stay away from auto hubs.

Tape as many of the plugs as possible along the loom to make it as narrow as possible and with a partner slowly draw through the firewall into the vehicle, do the opposite to reinstall carefully).