Search:

Here you go

https://www.marks4wd.com/low-range-overdrive-gears

Its a HF radio, a box full of electronic boards. The antenna is the transmission site and at 100w at 8ft off the ground,1500mm away on the rear of the pod, nothing of any concern. There are no gamma...

Looks good, the extra pipe length would add restrictions in the order of 4 decimal places - not an issue, clever about the drop end to keep the water out. I have never had a problem with my forward...

OK, so the UHF radio goes in the POD as well? I don't think you really thought that comment thru. Maybe i should put the water tank back there as well to save on tire wear on the front wheels? The...

Mark, I have this conversion and I am now sitting in the sweet spot for max economy at 110klm/hr at 1750rpm.Unlike the 85% reduction gears that howl all day in low range the machine finish is...

Its a mounting bracket for a Codan HF radio. Its mostly behind the headrest, but i am going to chamfer the stiffeners to take away the sharp corner - funny what you dont see when you are making it....

Fabricated another custom bracket to mount the Codan HF radio, time consuming and converting ideas into reality - came out well, mounted above the SS water tank behind the rear seat...

Got the rear pod wired 95% today, power to lights, inverter, DCDC, fridge, exhaust fans on thermostats, just need to do the penetration to get the charge cable into the pod - maybe tomorrow. Lights...

I think this refers to the diaphragm valve inside the pump so it sucks in liquid and the valve closes then the diaphragm discharges against the closed seal, pretty normal, there will be a flow arrow...

So you think the issue happened before you installed the 20mm body blocks ? Is there a witness mark on the bonnet or the barrel? Where was it rubbing? Are you sure its not a manufacturing leak? Can...

The diaphragm pump has a poor suction capability, which is why they only rate the discharge head. You will do better lowering the inlet of the pump to the same level as the tank outlet, then it...

Looks like I am up for a new or remodelled interchiller tank. The location of the tank outlet was deliberately put at 1/3 off the bottom of the tank to reduce any drawdown of crap into the pump...

The heat exchanger is on the rear of the fridge, the jackets provide the insulation to the sides and top.

Sorted the Interchiller pump out today, conductor size and volt drop. Rigged up a 200a/hr lithium and short heavy cables, fired the pump up, guaranteed 40lpm by the flowmeter thru the system, happy...

Where did you source these bins? I ran these in my original susyem and they are great, but local Bunnings stopped carrying them, and everything else apart from some $0 tubs in a single size work.

Who is this directed at?

Another good optimisation, thanks.

Thanks Mark, yes that will work also, sealing it up has some issues if the welds crack or I dont do a good job on the checkerplate. I dont need the weight as you mention. Back at the computer again...

No just the packing, all loose, tacked them together today, took 20 mins, after spending 7 hrs fighting with the interchiller pump, that has now been 100% confirmed as dead - pumped at 40lpm with a...

2 hrs transferring 4l of hydraulic fluid into the hydraulic winch tank, holy shit that pumping is hard work under the car. reconfigured the interchiller pump circuit back to standard, still a few...

Yes it's what sold me, I look like I can stack a large and 2 stalls on top of each other as two large are too tight it looks. Anyway will see, they have some good options, as do the expeditions

Procrastinating about the format of the rear pod, bit the bullet today and bought the starter pack from TRED, which has a 55L and 2 x 27L units. Combo seemed to work a bit better than the Expedition...

Slider kit finally arrived after 6 weeks - they must have been busy. Looks a good kit, precision made, all notched, just need to weld then paint, happy days. Going to plate top and bottom using the...

You can get these clips on ebay or via Patrol a Part, not expensive at all.

I purchased a unit that takes a plastic 30l bin, on the basis the last one ended up a pigstye with food and mud etc - will see how that works out I guess.