Search:

I did some research a few years ago and settled with "fuel doctor" to mitigate water & algae. I keep a sauce bottle in my driver door and squirt a bit in each time before adding fuel

Don't buy it...

My best effort was Kelmscott WA to Yungaburra FNQ in 4 day and 5hrs. No alcohol. No drugs. Plenty of sleep. When I'd get fuel I'd fill a couple of jerry cans, when I'd stop for a piss I'd tip the...

Evolution takes millions of years, not a couple of hundred. They haven't evolved to navigate traffic yet.

Thanks for posting!

Never cleaned a chain yet, usually just lube and sharpen. Will give it a go now

Glad you have the freedom to be able to walk away from your job!

Congrats

It can run like crap without an error code, I've done it when I forgot to tighten an intake clamp.

there are two blanking plates available. you can blank at both ends to reduce intake/exhaust...

It's very satisfying when aftermarket things fit perfectly :D

Welcome mate!

I hope to find out one day

I bought a black wolf one years back, the annoying thing was the width spec referred to the mattress being completely flat/deflated so when it was naturally inflated it was narrower than advertised....

What's difficult about it?

Still got the patrol, but also bought an MG ZS EV which I put the most kms on.

flushed my radiator until it was clean

What has made me happy today is I finally got my beast back together today and running sweet, I started in June last year, I don't like to rush things.

New timing chain, new injector pump seals,...

The tubes are gonna have to come off to put a new valve cover, more importantly, do you really need a new valve cover? I just had mine off, I think there was a rubbery ring inside the cover that...

The proposition looks viable to me :)

I did the same thing with a D250S although just had a small length of cable I kept ready to screw into position between the start & aux terminals on the Ctek...

mine was leaking like crazy, i just replaced it

the torque is 10-11nm, maybe loosen and re-torque?

87291

I drove for about 2yrs with the oil light on (I could not fault the car otherwise and know it's a common fault on zd30 engines)

Finally got around to replacing the oil switches. I replaced LHS...

Wow, good video! I might do mine as well, just for fun

fair call, I've actually got a couple of brand new spare hub/bearing kits sitting in the shed ... I might try swap them over tomorrow if it's not raining

I can't remember if I've even pumped my tyres up since I bought my trailer.

I did fit a remotely switched reversing flood light though, powered by a small battery charged by a 10w solar panel on...

I just changed my front rotors, the most useful part was a block of wood between the ground and the wheel studs to lock up the wheels as I cranked the hub bolts.

and pulling the fan into the radiator

I probably wouldn't worry until something is a miss personally, I'm near the 220k mark. I've had to replace the return line a couple of times because it goes brittle.

That is epic!!