Thanks to Dale,
I checked the squirter alignment last night, they were all good except for one in the middle (cylinder 3) was slightly off center to the hole in the piston, it would have been ok,...
Thanks to Dale,
I checked the squirter alignment last night, they were all good except for one in the middle (cylinder 3) was slightly off center to the hole in the piston, it would have been ok,...
Wife's car needs another key, best price was $425 supplied, cut and programmed, ring a mate at holden and the rest is in the happy thread.;)
I see you wearing this to next meet up cock!
Running a cooler via a oil filter adapter plate that I think has a valve that opens depending on heat.. all the cheap ones on ebay do not have this and oil runs through them all the time.
There...
Taaadaaa!!!!!53019
Sorry, you gotta transfer another hundred into AB's account
Cheers mate, I'm really happy with the outcome. I used a heat gun to stop the paint from cracking and just used a small shifter and slowly worked my way around.
Finally got the daily driver back on the road. Bloody repco gave us the wrong Vrs kit (incorrect rocker cover gasket) and wouldn't exchange as it was part of a kit.
Small fortune on gaskets...
although things may or may not have changed since this was done in 2003................ only saying ;)
Sorry, Rumcajs, but do you have anything to support this statement about China? From all the stories it is clear their service has been crap and will tell any tale but still not send. However, I...
Yeh , its not a "postage" problem, the second one I was sent (to replace the crusty one) arrived in just a week, obviously If you are lucky they have stock whe you order.
The problem seems to be...
100hp any less and something is up.
you have a pm :)
Yeah we use similar style tooling for our hydraulic pumps and motors for recond
Yep. There is a thread on the other forum dedicated to it. Has part numbers and all.
Your torque specs are wrong mate.
There are 3 different sequences depending on which td42 you have.
TD42
1- 49-59nm
2- 98-108nm
TD42T
Simple, your a male, she's a female. Didnt you know that all males under 25 are reckless hoons doing skids and racing.
I should know, I'm a male under 25.
The only way you will get an agreed value in excess of 15K is by car plus extra's of say 9,000 agreed for the car and 6,000 for the extras
A lot of the time modifications etc won't get you a single...
Top post Dale.
I pick up my TD42 Sunday... lol its going to be a little bit of a process I recon, but I will just take my time and ask lots of questions I guess..
Thanks for this thread...
Really I cbf'd searching lol!
I might not be fitting the turbo otherwise I would've lined it up that way. I was planning on tapping it next to the sump plug, should be low enough.....
...
Today I tested her out in the bush for the first time. I'm happy to say that apart from my brakes failing a couple of times (sorted now) everything went smoothly.
A few mates and I met up with...
Certainly was mate.
And just confirming for anyone else in eastern side of Melbourne, the only place for the test in our entire region is Knox.
very nice rig mate
It's only the high horse power TD42 after market turbo engines with the viper flywheels that seem to be breaking cranks & quite a few have broken. It isn't the balancing it's the weight of them...