Just spoke to vehicle standards re the LS9 & LS10
They have said that an LS9 & LS10 is only required for lifts (total of suspension, tyres & body lift) between 75mm and 125mm is required.
...
Just spoke to vehicle standards re the LS9 & LS10
They have said that an LS9 & LS10 is only required for lifts (total of suspension, tyres & body lift) between 75mm and 125mm is required.
...
Hi, I have spent most of today going over what is going to happen and talking to Vehicle Standards, here is the way I see it.
Tyres:- 50mm over what is on the tyre placard, so 33 look good on some...
No I am an approved Diesel Fitter, motor mechanic & now am also Certified in Truck, Coach, Trailer Body Building as well as an "Approved Person" under Queensland Transport. (I don't think NSW has...
Yes it is finally here in Queensland as of the 1st November.
Details as yet have not been released, but there are changes, most I hope for the better.
Engine Replacements:- was LA1 before, now...
Yes you are correct in what you say.
If you are building a Project vehicle you must have everything in writing.
First, everything you want to do on Form 1854 adding all the details of your...
Only too happy to help. If I know I will give you an answer, if not I will find out and then give you an answer.
Cheers
David
First question, did all this happen when you replaced the master cylinder etc? If so I would be looking at the free travel between the booster & master cylinder. Also look at the free travel between...
This now appears to have turned into advise for mods in Queensland that require a Blue Plate.
So ask away.
Cheers
David
0418 745 830
Hi, yes I can.
And if not sure Vehicle Standards are only a phone call away.
Yes I have seen & heard of some very interesting modifications
Cheers
David
Hi, there are a few correct answers and good information printed above.
In Queensland you do not have to get a suspension lift approved.
You will find that the legal lift (after doing your...
As of mid April 2012 body lifts do not have to have Queensland Transport Approval given first. They can now be Approved by an Approved Person, under the K3 Code.
Must comply to below:-
50mm...
Hi, this is just a bit of advise for all that are thinking about engine replacements.
The maximum size petrol motor that you can fit into a full size 4wd is 5.8lt/351ci.
Where as the 6.2 & 6.5...
Hi Todd, thanks for the welcome, I have sent you a pm for getting me added to the location area. I also paid to be a sponsor of the site this morning.
No I have never lived in Sydney.
And after...
Just a quick one, rally is at Smithton on Sunday 20th May. To rally against closures in the Arthur Pieman area.
Please attend and show your support, after all this is our country.
So if you...
David Metcalfe from Xtreme 4x4 Sport.
I have run the ARB XWC for 12 years now. Competed in the Malaysian RFC 5 times and attended it a total of 12 times plus one trip to RFC China.
I will also...
Body lifts can now be approved by an Approved Person here in Queensland.
Maximum is 50mm and the blocks must be the same diameter as the original body mounts, must use high tensile bolts with...