Search:

Mine has been smashed after the trip and i hate the flat plug.
So will be doing the same and mounting a round plug socket on the bumper..

Oh wow thought you had bought a Yota from the thread title.

Yeah never owned a crapple but do like android. We used to have iphones at work then went android. Everything seems to work much...

First Id change the hubs to manual locking not auto locking

Check the wheel bearings while you're at it.

Had a bump noise which increased when wet and finally found that the body mounts were worn.

It's not the spring moving a bit?

My front right coil makes a slight sound very clicky kind of sound and is definitely less prominent when dry.


Sent from my iPhone using Tapatalk

Fark mate..
Hope they were gentle removing your nuts..
Bahaha..
All bs aside they are a solid ute.
Good buy.

Put a long screwdriver or metal rod into the engine bay, touching the starter motor and get somebody to crank while keeping the other
end of the rod to the ear. That way you can pin point the...

Yeah that's the place. 20 years on from when I was there though but was an upmarket place even back then. Whatever you do, make sure you have a beer at a pub while watching the sun set over the...

If you are talking about the wires from the transmission sensor then you will need to use the two wires (blue and grey). I can not recall exactly but I would have used the vehicle ground to for the...

I've decided I'm going to hire a Thuraya XT-Lite for 2 weeks. I'll get an 04 number and tell people if they need me to ring me. Then when I want to contact them, I'll txt them (that's about half the...

Just a suggestion based upon the choice I made for remote Comms.

I looked at sat phones both new and second hand, and considered a spot device, as I wanted an epirb device too.

In the end I...

Ok received a reply from Ron and he says " he uses an old Iridium sat phone connected thru Telstra,
and when needed buys access for a month or whatever"
He's used all the other sat phones with...

I just got fitted Micky ATZ P3's today. Substantially quieter than the General Grabbers... stay tuned will give some feedback in a few weeks when we hit the dirt for a quick 4 day trip.

Cheers
...

sweet as, i love the idea.. ill have to factor some of this stuff into by build

It's because he had no internet for ages

Congrats Avo.

4k of posting tells me you've got a life, unlike some with nearly 28k posts. lol.

Yappy New Year, everybody - including Clunk. lol.

Yes unless it has the factory vacuum locker. I believe there were a few rare gqs that had open rears but very rare. 4.11s are cheap and everywhere. Most common ratio for a patrol

The only difference in splines was the 260s I believe. As you had coil and leaf 260 diffs. All 233s are the same.

Yes mate you have a H233 rear diff and your ratios are 3.5s

With such small quantities the margin for error is big enough to skew results, to get more accurate results you need to run to almost empty.
Another factor is how much petrol was used for start/warm...

Left Pakenham at 4.00am this morning with a full Tank of Gas and drove to Bendigo 200 K's

As Gas is cheaper in Bendigo (Go Figure) I decided to fill up and took only 17 Litres of Gas (ie 8.5...

If I may be so bold..... can I suggest the "SNIP" [emoji12]

Washed her properly for the first time since purchase in Aug 2015. Came up alright. ...

Rear drawers in..
69580