Hinges were so buggered and an ape had hung off them, the doors would not shut unless lifted over the door catch then pushed hard or pulled hard from the inside. The new hinges sorted that all out.
Hinges were so buggered and an ape had hung off them, the doors would not shut unless lifted over the door catch then pushed hard or pulled hard from the inside. The new hinges sorted that all out.
Swapped out the front door hinges today and away went tha clunk and double door thump. Also plugged in the electonics for the air/out temps on the intercooler and it worked first up, also powered up...
I really like what you ahve done there, really good configuration, obviously a bit of thought put into it, and good quality build, happy for you. Unfortunately I cannot steal any of the format as my...
Bought a set of sliders, with the single bulge at the rear door and the universal mount kit, will plate top and bottom with what I have left over from the tray, should come up well, bit of welding to...
My apologies, I have the ability to generate all sorts of doom, 'all by my own self' it seems.
Had the windows tinted today, heading back tomorrow to get them repaired after the old film shit was left on part of one window - like FM, really, where is the care these days. I get to waste another...
I can now confirm the Mother's product is a winner. After application of 3 coats on the vehicle and the canopy, not a single bird dropping, obviously works like a dome of invisible protection,...
I like the layout, plenty of space around the main items. I usually go for a more compact assy, and you have more room than my 1400 x 1800 canopy it seems.
Its funny, I was sitting in the waiting room whilst they worked their magic and the clientele were all old bastards like me - just so obvious, looking for a straight solution without fanfare. he...
Took the barge down to @MB's recommended muffler guy in Lilydale, excellent outcome, fixed up the problem i had generated in under an hour, pragamatic service, Lilydale Towbars and Mufflers - highly...
Better get the shovel ready, canopy got its first coat of slipperyness this arvo, turds will be flyin' off instead of sticki'
Thanks, I applied the first coat today, follow up with a second and third I reckon, Its a lot easier than the old Turtle wax for sure!
I am wondering around the oil pump and it being worn on the basis when the pressure increases the engine comes good? I did have a subaru that did the same thing - sorry similar - and it was valve...
87822878238782487825878268782787828878298783087831
Here you go, munch on this!
The entire inside of the car has a layer of Jing Ping acoustic vinyl insulation, followed by a 10mm layer of acoustic...
Thanks Mark, it was a mission. I took it down for a frontend alignment and heard it coming down the street for the first time ex the test drive - whine with a burble is perhaps the sound, the whine a...
Patrol didn't catch fire, breakdown or end up on the back of a tow truck today
Then again I didn't start it or attempt to drive it anywhere.
Nah, I like the concept of 'Driving Miss Daisy ' you can drive and I can sit in the back looking like an old queer! I have not heard it driving past but admit most people hearing it coming up behind...
Wrong gradeCraig. the ARP units are twice the tensile and tougher and have a special stress reduction knurl as well, lucky only 1 broke - Brunswick would not have a clue about this.
From the car that just can't stop 'giving', Starter Motor bolt sheared yesterday after I removed it from the sanctuary of the shed and brought it home. I stopped at a servo to put fuel in it, , drove...
Started the clean up at MB's shed today, found 8 off 10mm sockets, and 10 off 10mm spanners and 3 dozen screw drivers, on it goes, way over equipped now, but resultat of poor tool management during...
878148781587816
With rear pod and wheel/jerry can holders
Backing bar allows for fitment of solar panels that are slightly lower than the back rail, and has the alum roofrack approx 100mm above the...
I am not buying one more thing for my Patrol - hahaha, what a load of crap!
I will start with the first stage of release from the shed after a two year conversion from wagon to Dual Cab. Unlimited thanks to MB for his patience and allowance of this project to be commenced...
I am going to start one. The build has probably been the worst kept secret on the forum in all honesty, but the initial events and ramifications of the event that triggered the rebuild have remained...
Already booked in for another lobotomy as there is no chance I am getting talked into doing this again, might even get the ears sewn up as well after they plug 'em with peanut butter!