Search:

It's nice to see threedogs' recovery points in current issue of 4WD Action's recovery tips and tricks booklet.

http://www.nissanpatrol.com.au/forums/attachment.php?attachmentid=58440&stc=1

Watch out for dark spots in damp areas you will be digging and sinking for awhile they are like quick sand .drop the tyre pressures down to 15_18 psi go to low range and use the whole box you will...

Boggy Hole is a great spot follow the Hugh down too the Junction water hole and when you drop into the Finke just keep going . Best to go with a local to pick up the turn off or go the conservation...

And is a factory turbo.. Engine bay looks basically same as mine.. I am yet to plug my pressure relief ( it needs doing)

The "gold bolt" is a plug. There is normally a pressure relief there but they can fail and its common to plug them.

Catch can is up to you.

Battery is mounted the same as any other. Cranker is...

http://www.ebay.com.au/itm/K-N-AIR-FILTER-for-NISSAN-PATROL-GU-DIESEL-RB28QT-ZD30-TD42T-TURBO-DIESEL-/131488391063?pt=LH_DefaultDomain_15&hash=item1e9d519f97.

Here you go most buy two so ones...

Tylers Pass lookout & Tnorala is worth a visit if you haven’t made it there yet. http://www.nt.gov.au/westmacs/places/tnorala.
Serpentine Gorge is worth the walk...... possible to find some...

All looks as it should.

18 Bath st was my old haunt probably not there now
Dont forget to go out Finke way, there is a guy in town
who makes furniture from the redgum sleepers from the old Ghan lin
Polished 100yr old...

Looks a pretty tidy engine bay to me.... guess you need to look at some feral petrol GQ's getting around to know what is actually bad..lol

Cool, you dont have a MAF ,but you do have a 3LTR airbox, so a K&N filter would be handy x 2
Drivers side is your start battery well on my 3 ltr it is
follow cables to starter to check

Looks...

Just a thought on those cig outlets , throw them in the bin they will fail, especially now you'll be driving dirt roads a lot.
Search and find the Baintech rear merit and volt gauge that fits in the...

Ok - it's a 6AWG cable running from a 95AH deep cycle down the passenger side to the cargo area. The guy had this directly connected to the baintech x2 cigi sockets.
I would have had fuses or...

Should be ok but I would install a fuse at each end and the fuse must be one that protects the smallest cable size. That is to say that the cable the previous owner has installed might be say 20 amp...

I find it easier to run a thick cable to a fuse block that is fused at the battery.
I'm a big fan of blue sea fuse blocks like this one

Find a spot for it under the dash, passenger kick panel,...

at least 6mm for any power wires

http://www.ebay.com.au/itm/321464011399?_trksid=p2060353.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Thats all I did , just tapped into the power cable going to the rear power outlet.
Don't forget to fuse it at the battery end, I used these
...

I think I will need to set a night aside to reed your blog, good stuff.

Truck is looking good. Done much to it yet ?

I've seen that car before I think....hahahaha.
I hope it treats you well mate :)

well done Billy may you have many, many trouble free miles matey

Exciting mate should have your self a good rig there. Looking forward to you getting it and start the mods

Just checked it out.
Wow, its not white, its perfect.

Looks good mate. Enjoy.

Well done guys on checking it out and congrats on the buy, now if you need someone to drive it to Alice lol.

Funny..... I just saw that car on the banner at the top of the page, and thought mmmmmmmm that's nice..... Gorgeous, hope you're happy with it.