steve thats what this forum is about, help each other out where possible and especially guys like MR who have heaps of knowledge and isnt a bad bloke to go with it :)
steve thats what this forum is about, help each other out where possible and especially guys like MR who have heaps of knowledge and isnt a bad bloke to go with it :)
Doing the above job is the bush can be tough. If you smash a CV in the bush then you will not be installing a full kit through the front end as above to get you back on the road but it is recommended...
Grab a can of contact cleaner give it a good spray let it evaporate then try it.
It depends on what you find when you take the screws out and see what has caused the problem. Moisture may have caused some cables to corrode and make the joints a high resistance, which heats up...
Here is my first ever attempt at metal work and still have heaps to go but this is so far... it has held up to a rock ledge that I came down on hard with no damage at all.
...
Could be an issue with the PCV valve (air sucking noise)
The PCV sits on the inlet manifold between the manifold and the carby. There is a pipe coming up from the PVC valve that goes to the...
They are a good supplier. I purchased wheel and king bearings from them at a great price...
Onlineautoparts is the Ebay seller. They have >121000 feed backs at 99.9% positive.
They have a Xenon light with inductive pickup for $29.99.
They are in Geebung, QLD
Not a big risk at first...
I have an inductive timing light but I'm far away :)
If you have no luck borrowing one, they're only $30 on Ebay including postage..
^^^^^^^and there you have it..... have a couple of bears and the question gets answered see, works every time lol
You need to cut the wire at least 75mm to 100mm short at both ends and then install a stainless self tapper up the hole. If you don't do this then the wire will vibrate out of the flare with very...
The rf supressor will stp rf interferance to you am / fm radio and CB
You need to remove the condensor.
With a GT40R you need to have a ballast resistor.
If you upgrade to a gt40 or a pertonix coil - then you remove the ballast (just connect all the wires...
Mate 15x8 rim will be fine for your tyres I would guess that 99% of 33x12.5R15 tyres are on 8" wide rims in Australia. Just make sure you get decent quality rims, procomp ROH or Dynamic are all...