OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Search: Search took 1.00 seconds.

  1. Replies
    4
    Views
    1,605

    Blocking the boost reference to the wastegate is...

    Blocking the boost reference to the wastegate is just the idiots way to make more boost.

    I still have no idea why you would pull the throttle linkage off the pump to find a noise
  2. Replies
    4
    Views
    1,605

    Injector throttle link?? Whst do you mean by...

    Injector throttle link?? Whst do you mean by that?

    If the noise is definatly coming from the turbo pull the intake piping and dump pipe off and check it shaft play, up/down and front to back. Rub...
  3. Replies
    14
    Views
    5,142

    Mine was diagnosed using compressed air to remove...

    Mine was diagnosed using compressed air to remove any built up diesel on top of the pump and watching for it to reappear there are three "O" rings in the top, one is a big sucker that's shaped , one...
  4. Replies
    14
    Views
    5,142

    Yep clean the pump, degrease it and inspect where...

    Yep clean the pump, degrease it and inspect where it's leaking from.

    Fingers firmly crossed it's the the top seal as you can replace it without taking the pump off, otherwise pump out.


    Sent...
  5. Replies
    14
    Views
    5,142

    Had this happen to me too. It was the top cover...

    Had this happen to me too.
    It was the top cover sealing ring.
    I had mine replaced without removing pump..cost around $200.
    It hasnt leeked again that was 2 years ago
  6. Replies
    14
    Views
    5,142

    i had the same thing turned out to be one o ring...

    i had the same thing turned out to be one o ring under a plate on the pump. about 5 mins to change it. degrease the area look for a wet patch to form.
  7. Replies
    18
    Views
    12,275

    I don't know the answer to that mate, hopefully...

    I don't know the answer to that mate, hopefully someone else can jump in here, if not ring Patrolapart on Monday and ask them about it and the correct bolt/fitting to sort it.

    In regards to is it...
  8. Replies
    18
    Views
    12,275

    Factory sway bar disconnect issue

    Someone has just taken the bolt out mate.


    http://www.nissanpatrol.com.au/forums/images/imported/2017/12/64.jpg


    Sent from my iPhone using Tapatalk
  9. Will handle a mild turbo setup well if as you...

    Will handle a mild turbo setup well if as you said the compression checks out. I have about 250k on each of my patrols and apart from the breakages on my GQ (gets used for what its built for) the...
Results 1 to 9 of 9