g`day Jimmy
welcome on bord mate
heaps of laughs and bucket loads of info here enjoy
nowoolies
Paul
p:s piccies we luv piccies
g`day Jimmy
welcome on bord mate
heaps of laughs and bucket loads of info here enjoy
nowoolies
Paul
p:s piccies we luv piccies
Hello Jimmy.
All Patrol lovers are really welcome people here - I can admit. I can write not a percent of Aussie english and have always got help here.
There is AllOverWorld trip going to happen...
G'day Mate - Welcome aboard join in when you are ready and have fun mate plenty to do see and if u have any problems just ask and im sure u will get an answer !! Bucket loads of usefull information...
Hi and welcome to Nissans Nut House Jimmy
Tim
welcome aboard jimmy enjoy your stay mate
nice looking rig there bit like mine lol
Welcome aboard Jimmy. Lots of friendly people with good advice. Enjoy the forum.
Welcome to the forum Jimmy, enjoy mate
g'day Jimmy and welcome aboard mate
I would say it was just coincidence as well.
Going by the photos I would say your brushes have worn out and this has caused excessive arcing on the commutator.
It is reasonably common for a...
Welcome to the forum mate
G'day Jimmy welcome aboard your GU is certainly a good lookin truck the only improvements would be if it was a white GQ hahahahaha they're a good mob here full of great info and advice
G'day mate - Welcome aboard. Great people, information and forum laughs, so don't be shy and join to make the most of it. Enjoy!
Welcome Jimmy. Join in the conversations and enjoy
I'd say pure coincidence that this happend after running out of fuel.
Are there any auto electricians in the area that can recondition starter motors? Would be a lot cheaper than replacing it.
...
Welcome to the forum Jimmy,
Tony
G'Day Jimmy, welcome to the forum mate. Good looking rig there , the best model around :)
Welcome Jimmy.. A beautiful truck you have.. Enjoy the forum..
Assuming a good efficiency of about 90%, it will take about 90amps at 1000W and 180amps at 2000W peak. From this website http://www.powerstream.com/Wire_Size.htm it appears that AWG 2 would be the...