Search:

Not that I know of mate. All of the rockit comps are held at janowen. The ironman driving challenge is on again out at springs4x4 park in a few weeks. (Can't make that unfortunately) Logan 3 car...

No worries. It could easily be done in a day. Just let me know and we can try to organise something.

Prob be a bit too early for me as I'm moving state so gotta get set up and stuff... But feel free to message if you run into any snags, or plans change etc. good luck mate!

I cant do all the work for you but would be happy to assist you.

Hey up mate. How soon are you looking at whacking in the turbo? I'm moving to North Brissie at the end of the year and would give you a hand if you're not in a rush? Would be good to meet a fellow...

Give it a GO mate! Will be so worth it!

If you get no joy here and it's not your daily I reckon you should give it a crack mate.

Have you seen my DIY on when I did mine?

If you take your time and follow my thread and just ask any...

Hi All, Ute is SOLD Cheers

OK .... further to above :

My son and the trailer got back in one piece. Unfortunately the Tassie leg had to be postponed as we were unable to get spots on the ferry for two trucks over 2.1heigh...

Here is the link guys, I hope it works ok.

https://www.facebook.com/PidDieselEngineering?fref=ts

If you look at a swaybar, it connects each end of the axle together in relation to the chassis.

So when one wheel goes up, the swaybar trys to lift the opposite wheel up, likewise when one goes...

Hi bud. My mate had the same fridge and same problem, was replaced once because of it, and last time we were in the high country, it began happening again. The second time around from memory, the...

Depends how fussy you are (or how poor), but theirs a few other barriers that'll fit. Little or no work to fit them too. Mines a Magna one. Its a little low at the top, but that suits the fishing...

Ring Aus tyre and wheel on cnr of Ashmore rd andNerang-southport road and ask. He is the cheapest I have found for Maxxis

Put it this way it is worth my while to pay his price for sticky treps...

Hopefully you can see enough, as you can see I've got a few bracing bars, possibly more than needed lol
Also I accidentally put the mesh against the seats when I think it would be best putting the...

Yep not a problem I'll gram some tonight for you, I did go a bit overboard on mine though lol

If you wanna weld a simple 25x25x2.5 shs and mesh.
If you do a full run a bar across the middle where you bend to follow the seats..

Bumped , measure it up as most might fit just different brackets used

Congratulations. I remember the all of the excitement when I became a first time father. Enjoy the journey, mate.

Congrats mate, she is going to Blow your Mind mate!! My little girl owns me!

Congratulations!!!! If you don't already its a great time to invest in a shotgun and perfect your aim coz in 15/16 years time you'll be needing it! Lol

Congrats mate.

Congrats 2 you and the missus mate

If one makes u happy, imagine what more could do, PM me your addy and I'll send you a couple more :)

Congrats mate!

tell him the truth clunk...

hey mate congrat's to you and your better half,coming from some poor bugger with 4 of them,but everyone of them is a princess.