'The Pinnacles' - Western Australia.
http://i1015.photobucket.com/albums/af279/DXgrunt/IMG_0756_zpsy9ikegjm.jpg
'The Pinnacles' - Western Australia.
http://i1015.photobucket.com/albums/af279/DXgrunt/IMG_0756_zpsy9ikegjm.jpg
Check your oil level on the dipstick, which is now called an oil guage I am told. If you have overfilled, and I think you have, I think the 8.6 is correct, you may have oil leaking from the...
http://www.ebay.com.au/itm/PRO-Intercooler-COOLER-FOR-GU-Patrol-Common-Rail-3-0-turbo-diesel-2007-2012-ZD30-/231411893100?pt=AU_Car_Parts_Accessories&hash=item35e139436c
Maybe this tigged IC and a...
The canister is two parts the bottom 2/3 screws off, it also has a dipstick on the top, so you can see if it needs emptying....(it really is a nicely thought out and made item)
http://www.autospeed.com/cms/article.html?&A=112617
Heres a link I've forgotten how to set the parameters so feel free to post them up.
The project box I chose is from Jaycar and is ABS plastic,...
http://www.nissanpatrol.com.au/forums/showthread.php?14469-Digital-temp-controller&highlight=digital+temp+controller
Heres the thread the controller is only $16 free post on Ebay
...
I did a DIY thread on it a while ago I'll try and find it for you
...
Well for me so far it is a digital temp controller off eBay for the engel fridge. Just set fridge to max and it stays within 1* of set temp.
49956
49957
Looks the good now mate. Wish mine was as tidy
Yes you can improve greatly on the cheap ‘throwaway’ reg supplied with your panel. A few things to consider.
1. Regs fixed to the rear of panels are not in a good place. A reg close to the battery...
I sincerely hope it wont be necessary, but if it is I do have a recommendation. One I like to give because in my 27 years in Australia this place is the ONLY workshop I have ever experienced that I...
As long as my arse points to the ground and I have my GU, I see no end. :thumbup:
Below is my winch, the motor heats up pretty quick, it is beer cooled.
45395
Hi all here's a contact for those wishing to make their own rear wheel swing away carrier.
Martins trailers in Perth 08-9279-5777 sell the stub axle, bearings and a blank boss to use as a pivot...
here is the link to it mate its not a bad read
http://www.nissanpatrol.com.au/forums/showthread.php?89-Nissan-Patrol-Reference-Document
Just ordered a tigerz one. Hate the plastic coil hoses most come with so will see how it goes.
BC
Had this problem with my 07 CRD DX and was extremely frustrating. Much hair pulling and teeth gnashing! Changing clamps etc.
I do my own servicing and the solution was simple - don't use...
Check the other end of the pipe mate. Exhaust end. I have the plates made for the intake end anyway. Just pm me your addy and I'll send ya one. That plate you have is more common on the CRD 3.0L...
You took a much better photo than me.
Email sent mate. From an 08 CRD Wagon. For everyone else's reference:
http://i825.photobucket.com/albums/zz171/teno45/th_20130604_192548_zpsa0778a51.jpg
Darn... beaten to it!
Not sure if anyone sent it yet.
Have emailed it too.
Sorry Beni, the AVG display is measured in litres per hundred klms.
LHK measures litres per hundred klm as an instant snapshot of your fuel usage, so when you plant your foot going up a hill it...
I don't think I even looked at that sorry mate, so mine would just be however it was setup out of the box :)
I found using the AVG display for fuel usage to be the most friendly, LHK display can...
The inbuilt boost setting in the gauge now is accurate, no need to adjust for atmo. I have a mechanical boost gauge as well as the Scangauge and readings are pretty much the same, the Scangauge is...
Hi Beni,
I've seen reference to past 'debates' on Alloy vs Steel, I suspect it's probably a ford/holden type thing with some folk arguing to justify their own purchases & it's probably not worth...