OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Search: Search took 1.00 seconds.

  1. Replies
    3
    Views
    1,182

    If it has a grease nipper, grease it.. I...

    If it has a grease nipper, grease it..
    I personally use a high impact grease, will find out which one when home..
    And use quality oils in the diffs and gearboxes.
    As for rust protection there are...
  2. Replies
    3
    Views
    1,182

    Can't hurt. Lanolin spray is good. All the tie...

    Can't hurt. Lanolin spray is good.

    All the tie rod ends have grease nipples and should be serviced regularly along with the Uni joints in the front and rear drive shafts.
  3. I have also found Ferntree Gully Nissan to be...

    I have also found Ferntree Gully Nissan to be really good as well, if they are a bit closer to you

    Mic
  4. I agree patrolapart and from experience they...

    I agree patrolapart and from experience they don't seem to charge an arm and leg
  5. The boys at Patrolapart in Lilydale are quite...

    The boys at Patrolapart in Lilydale are quite good.

    I just dropped mine off there today and have a full report back on the phone before they even begun letting me know what needed to be done and...
  6. Replies
    2
    Views
    1,450

    I'm on the phone so can't give a link but try to...

    I'm on the phone so can't give a link but try to find my DIY thread for installing a 4" stainless steel snorkel.

    The nibbler is the winner mate!

    Drill a hole in the centre put the nibbler...
  7. Replies
    2
    Views
    1,450

    Measure three times and cut once, guy doing mine...

    Measure three times and cut once, guy doing mine used an air hack saw.
    Didn't see any special tools, make sure you paint/treat and bare surfaces
    Have heard stories of PPL cutting the hole in the...
  8. I think 04off has a lokka brand locker you could...

    I think 04off has a lokka brand locker you could try giving him a pm . I have also read about removing a part from your auto hub and it becomes manual only that way you can save some coin
  9. LED Light Bars - South Australia Government - Seeing the light!

    Not sure if anyone has posted this on here yet?

    40664
  10. Replies
    20
    Views
    7,168

    I got 2 blokes to sport led light Co. 's aroura...

    I got 2 blokes to sport led light Co. 's aroura 10" bars.
    A little dearer than the rest but both are extremely happy with them.
    One has his roof mounted on his rodeo. Has a pair of 5" spotties up...
  11. Replies
    20
    Views
    7,168

    Fyrlyt have a pretty awesome output but they...

    Fyrlyt have a pretty awesome output but they would want too as they pull a poo poo load of current and the globes are unique so are therefore expensive and can be hard to get.
    IMHO I would spend the...
  12. Replies
    20
    Views
    7,168

    I've got 22" 5 watt light bar x3 and also a pair...

    I've got 22" 5 watt light bar x3 and also a pair of lightforce with a 100w hid kit in them, I can tell when I have my spotties on as they are a spot so they outshine the light bars in the centre,...
  13. Replies
    20
    Views
    7,168

    I would not waste my time with spotlights again....

    I would not waste my time with spotlights again. I have HID spotlights and with my LED bar on I can hardly tell that the spotties are on at all. No comparison.
  14. Replies
    36
    Views
    28,785

    NissanPatrol.com.au and Patrolapart.com.au Alliance

    Hi Folks,

    I have some exciting news for the forum and for the members here!

    I have been in discussions with Patrolapart for around 12 months now on how we can form an alliance to help each...
Results 1 to 14 of 14