Good on ya mate. It's an absolutely fantastic generous deed and a great example of recycling useful things.
Cheers.
:cheers:
Dom
Good on ya mate. It's an absolutely fantastic generous deed and a great example of recycling useful things.
Cheers.
:cheers:
Dom
Fuel and the outback – Food for thought…
Just thought I’d offer a bit of advice with regard the owners going or contemplating going outback. Seems to be a lot of misinformation on this issue. In...
How do you go about servicing starters and alternators?
Sent from my GT-I9100T using Tapatalk 2
Clutch master rebuild.
Service Starter mtr .
Replace all water and vac hoses.
Flush cooling system.
before you remove manifolds.
New thermostat.
Service alternator.
list is endless
Take a pic at each stage, so you can go backwards threw your folder and install everything how it came off..
Kallen Westbrook
Owner of
Westy's Accessories
Gasket remover & / or a good narrow paint scraper.
Make sure you got all the necessary parts before you start.
Allow another 1/2 of the time, because it always takes longer. Start on Saturday...
Yes - the left side on the driver's side shows nothing:
http://www.imagerocket.net/photos/1351572937_20121030_101912.jpg
This machine's wiring is a mess; is it possible that someone has ripped...
Body swap fairly easy
All fuel lines ect are on the chassis,so no need to touch fuel system ect
Youll have to disconnect the brakes as the boosters are firewall mounted as is the clutch system...
Yeah mate I have had a rear seal go and a mate had the exactly the same problem as you and it was an internal seal.
Im with canuck!
Go to Jaycar andask for some Unick, it is a heat transfer compond they use on mother boards and other bits on computers.
It is a white paste type stuff just pump a bit of it in the...
Hi Lachie.
Did the engine stall in the water or did you shut it down?
I would say the cause of your oil light coming on is a stuffed sender (full of water).
But to be sure you can take it to...
hey I will put pictures up in the post in the next couple of days.. im on my work pc and they dont let me do it!!!
Nope - it wont work unless one end is earthed (the case) and the other end is connected to the power rail (+12 volt). With it not connected you may get alternator whine - a noise in the radio (and...
That's exactly what it is.. It's a noise suppressor.. the wire will run to the main battery bolt on the back of the alt and the unit just bolts to earth.. they are used to cancel out small voltage...
My thoughts exactly
Looks like a Radio Interference suppressor. It looks like a piece of the mounting bracket has broken off (probably due to vibration). You will most likely find the rest of it under a screw...
From memory it cost me about $100 for boost and $150-180 for pyro, 2" gauges. I got my guages from VDO at Archerfield. Have a look on Ebay for them.
Tony
When you said BOV earlier I was thinking closed throttle blow off valve (BOV) which is not relevant to diesels. I realize now you referring to the over boost pressure relief valve which I think is...
GQ diesels had mechanical injector pumps so no MAF sensor.
Tony
Black smoke indicates incomplete combustion/unburnt fuel, so maybe a blown turbo or a muffler dropping a baffle and blocking the exhaust. That does not tie in totally with the engine stalling though....
G'day all,
Auto hubs are the same GQ and GU, they are an auto hub (much the same as any other auto hub) except that they have a manual over ride that allows you to manually lock them in using the...