Finally got around to replacing the handbrake cable and while it was simple enough (took a few hours) there was not a lot of info on it here so I thought I would add some pictures of it going back...
Finally got around to replacing the handbrake cable and while it was simple enough (took a few hours) there was not a lot of info on it here so I thought I would add some pictures of it going back...
That is a pretty average run mate. My condolences on your Mate and hope your ok. The fact you had to do the Welfare Check and discovered the poor bloke is testament you your friendship and your...
Hey Dean, you're doing well mate! Keep it up.
Sent from my SM-G960F using Tapatalk
I can't help you too much with fitting.. but I can tell you if I was going to go to the effort of fitting and plumbing in an intercooler I'd fit something a little more substantial than the factory...
3 cheers for Deano2506 hip hip horay, hip hip horay, hip hip horay
Reckon 90% of problems are either vacuum hoses or earth straps lol lol
The mrs is using expressvpn folks.
Sent from my iPhone using Tapatalk
You shouldn't see any difference in engine temps.
Mine is actually a GQ engine in a GU. It's a '96 Safari factory TD42T imported from Japan.
After having issue with a stuck proportioning valve on my GQ trayback, stripping it down and seeing the corrosion inside meant it needed replacing I set off looking. I was horrified to see...
The other thing I thought about doing, was to glue a block of foam to the top of the standard one and wrapping it with some sort of material
AB there's a market here for you mate!
72473
A nice forum logo on the back, good for right and left hand drive country slouches :-)
It's roughly 2 inches taller. It makes for a much more comfortable drive.
I was the same as Clunk and had to buy a whole console. Can't remember how much I paid but I sold the standard height...
Just remembered that bracket , because to replace the top seal in the injector pump I need to remove the intake manifold and that bracket with it .
Correct. The one that is just bent at 90 degrees mounts to 2 of the exhaust studs and the other bolts to the intake manifold to support the airbox. The kit should have come with instructions.
I think I've seen bracket mounting on each side before, it's a pretty big air box!
Flip the air box and see if those brackets match up to the box on fixings?
Sent from my iPhone using Tapatalk
Nah it wouldn't be a bracket for the turbo, I would say both of those brackets are used to mount the airbox.