Well done Lana.
Did you already have a relay for the fan in the box beside the battery? (Mine doesn’t)
Could you throw up some photos of your relay locations and wiring?
Hopefully this fixes you...
Well done Lana.
Did you already have a relay for the fan in the box beside the battery? (Mine doesn’t)
Could you throw up some photos of your relay locations and wiring?
Hopefully this fixes you...
Wiring diagrams emailed Lana.
Good luck with it. Wish I had the time to nut it out with you but if you need anything else just give me a shout
The factory a/c plug is on the left side of the radiator support panel. The one on the right, kind of near the back side of the headlight, I believe is for an external heat sensor if you have a Ti...
Hi Lana,
I went through the same process about 6mth ago with my 2016 patrol. The condenser fan is still sitting in the shed because, like you , I found lots of bits missing. I also have a plug in...
Lana if your intercooler is the original. Have a real close look at it for leaks. If you have any boost leaks at all, no matter how small, there is no chance of setting up the valves. Do you need a...
Lana, your mods to date are all good (exhaust & provent200) + the Scangauge (to erase possible errors resulting from blocking EGR assy.
Do agree with 4bye4:
I have Dawes on mine (happy) not...
Exactly how I would do it. Gauges in first. Well you need them in first anyway before you play around with and boost control. You need to see whats happening.
Others may disagree but I would suggest get your gauges in (pyro EGT and boost) so you can see what your motor is doing now. Then EGR block and NADS (Dawes/Tillex) your choice, I have Dawes on mine....
Just pry the auto clutch part out ==> see the image
72909
one on the left removed, one on the right still in.
Really easy job, lock the hub manually first, use M10 Allen key to remove six...
Job all done - By only removing fuel filter (left starter motor fitted). Posted method of attack for those interested.
I wanted to avoid removing starter motor to install the VDO adaptor T for...
I just use degreaser and then rinse it with water and dry it. I sometimes also use a bit of emery paper if there is build up on the housing faces etc. Use Marine grease for better water resistance...
Most winches I know of use grease in the clutch end, I've never had an issue repacking the ones I have serviced. There is a bit of a write up here on a Runva 11XP I did a few years back. ...
I was lazy and bought this and just made it fit...
http://www.ebay.com.au/itm/Steel-Fridge-Slide-Barrier-Cage-700mm-L-x-465mm-W-x-600mm-H-4x4-4wd-/142457030429?hash=item212b19c71d
Hey Lana.
First and not really a "bad" thing but still annoying me is. The slide is super tight in mine as well as another mates that i've noticed. I have to brace my foot against the car and then...
I hope you checked all the bearing bolts , before the install or you may find one or two falling off .
Slide latch looks cheap is cheap but is remarkably strong , mine has survived Wonnangatta, big...