OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Search: Search took 1.00 seconds.

  1. Replies
    14
    Views
    8,267

    Hmmm nothing in this post makes sense?? Sorry. ...

    Hmmm nothing in this post makes sense?? Sorry.

    With a turbo it gives you better low down grunt and don't need to have it revving flat strap. Is that how you have to drive a 3.0 crd. I now have...
  2. Thread: King springs

    by Dam355
    Replies
    18
    Views
    14,697

    Very happy with my king springs. 2" lift. Made a...

    Very happy with my king springs. 2" lift. Made a huge difference.
  3. Replies
    60
    Views
    10,673

    Hey RLI, I have done the same as you with the...

    Hey RLI, I have done the same as you with the Kinugawa. Had it in 5 days!

    I am sick of the crap service I am getting ATM.
    Bought a Dewalt hammer drill 2 months ago from a tool place and it broke...
  4. Replies
    3
    Views
    1,817

    Welcome... I am about to do the same - can you...

    Welcome...

    I am about to do the same - can you not just cut it out? If you rip the bonnet lining off you can see where the intercooler cut out kind of is.
  5. Replies
    11
    Views
    4,536

    Is my GU 4.2 n/a too old for turbo!!??

    I would be checking the compression and is that's ok, Go for it.
    Don't run over 8-10 psi

    Quite a few guys have done it and not had any problems.
    I am putting one in on my 2000 NA. In 2 weeks...
  6. Replies
    14
    Views
    4,430

    Fitting 2 inch lift

    It's very easy. Did mine a few months ago - should take about 20mins a wheel.

    I also used a bottle jack to push the front diff down from the chassis. The springs fell out.

    Make sure you...
  7. Replies
    41
    Views
    20,364

    What parts required to turbo TD42 GQ

    This hole is for the oil feed to turbo.

    Need an Allen key and will unscrew - maybe need a bit force.

    Need a 1/8 adapter - this kit fits.
    ...
  8. Thread: Kyb shocks

    by Dam355
    Replies
    11
    Views
    6,743

    Kyb shocks

    Ed_Glxi - I see you have posted this question in 4 different areas. Maybe go to the introduction area and introduce your self there.

    Then start a thread in the correct section - not the KYB shocks...
  9. Thread: Kyb shocks

    by Dam355
    Replies
    11
    Views
    6,743

    Kyb shocks

    I have had the KYB scorched 4's in my rig for close to 4 yrs. they have been great - I am running a 2" lift. I have never tried anything else.

    Cheers.
  10. Replies
    138
    Views
    153,625

    Sticky: Forum register of West Aussies

    Dam355 Perth Metro.
Results 1 to 10 of 11