OUR VIDEOS GALLERY MEMBER SPONSORSHIP VENDOR SPONSORSHIP

Search:

Page 1 of 4 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    2
    Views
    1,360

    You need to check the pressure in the fuel rail. ...

    You need to check the pressure in the fuel rail.
    If the pump is not supplying enough pressure and flow, you'll get rough running and backfire.
    Does your Troll run clean if you floor the...
  2. Replies
    3
    Views
    1,682

    Yeah - ha ha. Plain english, aussie bloke/shed...

    Yeah - ha ha.
    Plain english, aussie bloke/shed method.

    On the end of the hose that goes from the fuel filter to the engine, temporarily fit a 3/8" (8mm) brass tee and an extra bit of fuel hose...
  3. Replies
    15
    Views
    7,661

    Thanks - your instructions are easy to follow and...

    Thanks - your instructions are easy to follow and the fit-up is very simple

    I run something similar using a 5 pin relay.
    The park light power goes to the centre pin, the reverse/camp floodlight...
  4. Replies
    14
    Views
    2,598

    All sorts of screams will come from what I'm...

    All sorts of screams will come from what I'm about to say..........

    "Use sump oil, and turn the chain oiler up full"

    Sump oil (engine oil) contains detergents. Plenty of oil helps the cut and...
  5. Replies
    25
    Views
    3,916

    Yeah - but they post a lookout.................

    Yeah - but they post a lookout.............. "CAAR, CAAR! "

    Trouble is they still get cleaned up by trucks and motorbikes.

    As far as roos go, the best way to avoid hitting them is not to have...
  6. Replies
    6
    Views
    1,360

    You realise the headlights in a GQ are earth...

    You realise the headlights in a GQ are earth switched.
    That means the "normal" earth lead runs 12v power through the fuses, and the leads for low beam and high beam are earths through the column...
  7. Replies
    9
    Views
    1,496

    Have use moly grease in the slide pins for years...

    Have use moly grease in the slide pins for years (cv joint grease). Doesn't seem to bother the rubber pin seals
    Tried silicone grease once and they gummed up before the next oil change - silicone...
  8. Replies
    1
    Views
    1,313

    To clear TB42E ecu, remove battery terminals, and...

    To clear TB42E ecu, remove battery terminals, and put the terminals together to discharge any current left in the system.
  9. Good to clean out the threads in the block with a...

    Good to clean out the threads in the block with a thread tap if you've got one. Surprising how cruddy they get.
    Remember to make sure there is nothing (grease. oil, crud, gasket debris) in the...
  10. By the look of it Crusty, it's surplus to your...

    By the look of it Crusty, it's surplus to your needs.
    It's an electrical controlled vacuum solenoid. Could be for a dozen different uses including your suggestion for the vapour cannister.
  11. Replies
    15
    Views
    7,662

    With the colder months, the tyres park up warm...

    With the colder months, the tyres park up warm and cool overnight. So where tha tread sits on the ground the nylon of the plies and the compound can "set" a flat spot.
    The colder the temperature and...
  12. Replies
    15
    Views
    4,258

    Crossed plug leads - check your firing order.

    Crossed plug leads - check your firing order.
  13. Replies
    5
    Views
    1,205

    I've checked this out (in theory) A commodore...

    I've checked this out (in theory)
    A commodore external pump puts out sufficient flow and pressure to run the TB42E
    Divert the wiring to it and you would have to put a bit of fuel hose in place of...
  14. Replies
    496
    Views
    252,147

    See the little washer nozzle above the clearance...

    See the little washer nozzle above the clearance light ??
    When cyclists piss me off, .......... I piss on them !
    83645
    83644
  15. Replies
    14
    Views
    4,542

    When out bush with poor radio signal (am/fm),...

    When out bush with poor radio signal (am/fm), knock a tent peg into the ground and pour a billy of water over it.
    Hook a jump wire between the radio aerial base and the tent peg.
    Works brilliant...
Results 1 to 15 of 57
Page 1 of 4 1 2 3 4