PDA

View Full Version : My gq drawes



stevsr31
5th May 2011, 07:46 PM
Hi here are the drawes I made did not think to take any shots till after I started work fine :)

Bigrig
5th May 2011, 07:59 PM
Hi here are the drawes I made did not think to take any shots till after I started work fine :)

Very neat and tidy job mate!!

AB
5th May 2011, 08:06 PM
Very impressive mate!

Ten times better then my timber ones...LMAO

NissanGQ4.2
5th May 2011, 08:07 PM
Very neat and tidy job mate!!

x2 very nice

Clunk
5th May 2011, 09:46 PM
them there are some pretty saucy looking drawers mate

growler2058
6th May 2011, 07:12 AM
Very good job mate well done

nowoolies
6th May 2011, 09:10 AM
not three bad at all ............where`s mine?????

fixer982
6th May 2011, 10:00 AM
Nice work Steve. I wish I could work metal like you obviously can. If I had made mine out of metal, even with a MIG they would look like swiss cheese.
My timber ones are not that neat now, though I was pretty proud of them when I first made them. I used the sliding shelves from a computer rack, which have pretty good ball bearing runners.
The most expensive part was the marine ply and they are a bit heavy, but cheaper than ARB etc. Pity I made them a bit higher than I would like but they hold lots of s**t.

mooney
29th May 2011, 06:51 PM
how did you make the fridge slider part

jazza_v
30th December 2011, 04:21 PM
very nice good job

sibbles
6th January 2012, 09:13 PM
Love it, do you have all your slides on bearing and no commercial sliders in them. Did you make the sliders from steel or aluminum?

Dapple
19th February 2012, 08:14 AM
Nice job did you shape the metal yourself or did you buy it like that?

thebeatjackson
19th February 2012, 09:59 PM
looking good mate, might need something like that for my truck!