kdfr42sp3r-8 king springs ???????

[jay see]

I've got a chance to get a set of kdfr42sp3r-8 king springs. Having a look at the king spring website all it says for theses are that they are available for both GQ and GU.
Can anyone advise if these are suited to a series 1 GU, I'm after something that will suit the extra weight of a winch and bar.
Cheers

[growler2058]

You need to tell the supplier what sort of weight you're gunna load em up with. mate

[happygu]

Pretty sure these are Progressive rate Springs, at a 3" lift.

Depends what you are after, but I think they will be fine.

Put them in, measure the height between the bottom of the flare, and the lower edge of the rim, and write it down.

Put the winch and bar on and re-measure - if the height is still acceptable then it should be all good.
Check again after a few months to see if they sag....

[happygu]

oh and they will fit the Series 1 GU just fine too

[jay see]

Thanks Happy.
Already have the winch and bar on, using standard height shockers don't really want to go higher than 2".