Truck rolled and bent windscreen frame

[john h]

Does anyone have dimension for the windscreen frame. My GQ fell off a sand hill the other day and gently and landed on it's side but with enough force to pop the screen out. I was just going to use a port a power to straighten the screen but don't have any dimension to work off. I waiting for the new screen to arrive but thought I could pull it square in the meantime.

Doesn't seem to have done much damage as doors open and shut and the roof gutters haven't cracked, just has about a 10 mm gap at the top front of the drivers door.

[AB]

Hey mate, sorry to hear that....have you got any photos of roll over by chance?

Have a look at this thread below which should have the dimensions your after mate.

http://www.nissanpatrol.com.au/forums/showthread.php?1085-GQ-Body-Dimensions-and-Specifications

[MudRunnerTD]

not sure on the actual measurement bud but it will be the same from both diagonals.

Measure from bottom corner to alternate top corner, when it measures the same from both sides your spot on mate.

If you have the old screen and at least one of the diagonals is in tact then that measurement is the one you need for both sides. Otherwise Law of average applies => they should measure the same ;)

Good luck

[john h]

Hey mate, sorry to hear that....have you got any photos of roll over by chance?

Have a look at this thread below which should have the dimensions your after mate.

http://www.nissanpatrol.com.au/forums/showthread.php?1085-GQ-Body-Dimensions-and-Specifications

Thanks just printe dit off so will see how far out it is

heres a snap of the it - not to bad as it went very slowly shouldn't have fallen over but I came over tehhill inteh wrong place and couldn't get back onteh track quick enough
http://imm.io/lRL6

[AB]

Shame mate, looked like a scary little off camber decent!